IKEA IR8GSMXRS03 Посібник з використання та догляду - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник з використання та догляду для Холодильник IKEA IR8GSMXRS03. IKEA IR8GSMXRS03 49 сторінок.
Друкувати сторінку
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
The refrigerator will not operate
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Power cord unplugged? Plug into a grounded 3 prong outlet.
Is outlet working? Plug in a lamp to see if the outlet is
working.
Household fuse blown or circuit breaker tripped? Replace
the fuse or reset the circuit breaker. If the problem continues,
call an electrician.
Control(s) on? Make sure the refrigerator controls are on. See
"Using the Control(s)."
New installation? Allow 24 hours following installation for the
refrigerator to cool completely.
NOTE: Adjusting the temperature controls to coldest setting
will not cool either compartment more quickly.
The motor seems to run too much
Your new refrigerator may run longer than your old one due to its
high-efficiency
compressor and fans. The unit may run even
longer if the room is warm, a large food load is added, doors are
opened often, or if the doors have been left open.
The refrigerator seems noisy
Refrigerator noise has been reduced over the years. Due to this
reduction, you may hear intermittent noises from your new
refrigerator that you did not notice from your old model. Below are
listed some normal sounds with explanations.
•
Buzzing - heard when the water valve opens to fill the ice
maker.
Pulsating
- fans/compressor
adjusting to optimize
performance.
Hissing/Rattling
- flow of refrigerant, movement of water
lines, or from items placed on top of the refrigerator.
Sizzling/Gurgling
- water dripping on the heater during
defrost cycle.
Popping - contraction/expansion
of inside walls, especially
during initial cool-down.
Water running - may be heard when water melts during the
defrost cycle and runs into the drain pan.
Creaking/Cracking
- occurs as ice is being ejected from the
ice maker mold.
The doors will not close completely
•
Door blocked
open? Move food packages away from door.
•
Bin or shelf in the way? Push bin or shelf back in the correct
position.
•
Crisper cover in the way?. Make sure the crisper cover is
pushed in fully, so that the back rests on the supports.
14