Gandy 36H12 Посібник оператора - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник оператора для Розкидач Gandy 36H12. Gandy 36H12 8 сторінок. 24” & 36” spreaders
Також для Gandy 36H12: Посібник оператора (8 сторінок), Посібник оператора (10 сторінок)

Друкувати сторінку

Assembly Instructions

1. Assemble Rotors

Place hopper upside down, unsnap and remove

bottom. Loosen wing nuts on bearing retainers in

place and remove bearings. Slide end washer and

bearing onto longer ends of rotor bars and insert

rotors into hopper's center bearing.

2. Assemble bearing retainers, spread plate

Place bearing retainers over bearings with SAE

washer and wing nut. NOTE: Retainer rods

must project away from handle side.

Secure one bearing retainer with spread plate

retainer rod in place with SAE washer and wing

nut. Slide spread plate assembly onto retainer

rod.

Insert rod of other bearing retainer into other end

of spread plate and secure retainer in position on

bearing with SAE washer and wing nut.

3. Attach wheels

Attach wheels on rotor ends with hair pin cotters

when using semi-pneumatic tires and with clevis

pins when using pneumatic tires.

4. Assemble Handle

Thread right angle of shutoff lever upwards

through lever guide loop on parking stand until

loop rests against stop on lever. Slip same right

angle of lever upwards through lever guide loop

on handle and fasten handle to stand with two

1/4 x 1-3/4" hex bolts, two wrought washers, and

lock nuts.

Attach 4-hole hook mounting bracket to under

side of parking stand-handle assembly in lowest

hole of handle, using 1/4 x 1-3/4 hex bolt,

wrought washer and lock nut.

Remove the whiz lock flange nut from stud lo

cated on the cam gauge side of the hopper. At

tach end of handle-stand assembly to stud with

whiz lock flange nut just removed. Be sure

shutoff lever is in slot on hopper bottom.