decoflame Montreal Посібник з встановлення та інструкція користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з встановлення та інструкція користувача для Внутрішній камін decoflame Montreal. decoflame Montreal 12 сторінок. Custom-made bioethanol fireplaces
Також для decoflame Montreal: Посібник з встановлення та інструкція користувача (10 сторінок)

Друкувати сторінку

Plasterboard walls – Stud-walls

All surfaces inside the wall cut-out are to be covered with fibre plaster sheets or other

non-inflammable materials.

This is merely a precaution as normal plasterboard might change its characteristics

over time when exposed to heat.

Stone/Brick walls

The cut-out is made according to the attached drawing.

The wall itself is non-inflammable which makes it safe to install a bioethanol fireplace

directly in the cut-out.

7.2

Exploded view showing the installation process (see 7.2)

1. The body of the fireplace (consisting of top, back and sides) is positioned onto the supports left and right below and

centred within the wall cut-out. Use the enclosed screws (inserting them through the holes in the top) to secure it in

place allowing for a perfect 5mm gap all the way along the top and sides. Make sure that the edges of the fireplace are

kept flush with the edges of the wall cut-out.

2. The bottom of the fireplace is lowered into the recess within the wall and is placed onto the lips protruding from

the bottom of the sides. Insert the enclosed screws through the holes in the bottom plate and the holes in the lips at

the bottom of the sides (if necessary using plugs suitable for the material which has been used to create the supports)

and fix both the body and the bottom plate of the fireplace to the supports.

3. The burner is placed in the safety chamber and the sliding lid is placed on top of the burner.

3.1 Orlando Only. Secure the frame using the included screws from the inside.

4. Optional Glass. Carefully secure the glass with the 2 included finger screws.

Remember rubber seals between screw and glass.

General Installation Guidelines "Bifocal Custom-made Fireplace"

It is essential to maintain a 5mm gap all the way around the fireplace (Cut-out =

Fireplace Dimensions + 10mm) This gap must not be sealed (see 8.1).

8.1