Bernal S 201-80 Інструкція з експлуатації - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Відкривач гаражних дверей Bernal S 201-80. Bernal S 201-80 17 сторінок. S 201 series
Друкувати сторінку
Error analysis
Lighting:
•
Light bulb defect:
Replace by a 24V/15W (E14) light bulb
•
Opener does not have power supply:
Check mains supply lines and fuses and replace if
necessary
Radio system:
•
Door does not react to transmitter signal:
Check battery and replace it if necessary.
Receiver did not learn / accept transmitter code;
repeat programming.
•
Unsatisfactory transmission range:
Check connection and placement of the antenna
and correct if necessary.
Check battery output and replace it if necessary.
Use a rod antenna
Logic board:
•
Door does not move at all:
Check if the inputs for safety device connection
(NOT)are bridged, or if safety devices are con-
nected
•
Door only reacts on signal of a push button:
Check placement of the radio receiver and correct
if necessary
•
Door stops during the movement:
Door is rough running, check door mechanic and
correct it (only by a professional!!)
•
Door reverses during the movement:
Check if there is a hindrance, remove it.
Motor:
•
Motor is running but the door is not moving:
Check connection of pushing rod and door and
correct it if necessary. Is the connection piece of
the chain or the belt engaged with the trolley?
•
Motor runs jerkily:
Gear of the motor defect. Replace motor unit
•
Motor does not start running
Check if the Hall sensor cable is connected in the
correct way (at motor and at logic board)
S 201
Radio system PICO, 868,5 MHz
2 channel
T1
4 channel
T1
T3
T4
Application: remote control for garage door and
gate openers
Technical data:
- Frequency 868,5 MHz
-
Coding:
KEELOQ®-Rolling
programmed by the factory
- Each receiver has a max. capacity of 28 transmitters,
which can be programmed
- Power supply: standard 3 V lithium coin cell CR2,032
- Range approx. 50 m, depending on the surrounding field
Battery replacement:
Loosen the battery cap on the back side of the casing
by turning it to the left side (see drawing) with your
IMPORTANT: Do not throw used batteries into domestic
waste; dispose them through battery recycling system!
Transmitter types:
2 and 4 channel
Conformity:
The radio system conforms to the standards of EN300,220-
3 V1.1.1; EN301,489-3 V1.4.1; EN60,335-1; EN50,371 and
may be put in circulation without additional registration in
the countries of the EU and in Switzerland.
HomeLink®-compatible:
The transmitter can also be programmed into HomeLink®-
systems of motor vehicles. Precondition is the relative
actual software state of the system integrated (beginning
with version 8).
15
Transmitting
direction
T2
Transmitting
direction
T2
Code
System;
finger. Insert the new
battery with its positive
pole forward into the
battery cap. Turn the
battery cap together with
the battery back into the
casing.
pre-
01-07