ENGLISH
Shelf supports
You can remove the shelf supports to clean
the side walls.
Removing the shelf supports
1
Pull the front of the
shelf support away
from the side wall.
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
Pyrolysis
Warning! The appliance becomes very
hot. There is a risk of burns.
Caution! If a hob is installed with the
appliance, do not use it at the same
times as the Pyrolysis function. It can cause
damage to the appliance.
1. Remove the removable shelf supports (if
applicable) and accessories from the
appliance. Refer to "Removing the shelf
supports".
Caution! Do not let the removable
shelf supports stay in the appliance
during the cleaning procedure. There is a
risk of damage.
2. Remove the worst dirt manually.
3. Fully close the oven door.
The cleaning procedure cannot start if
you do not close the oven door.
4. Set the function Pyrolysis. Refer to
"Oven functions".
2
2
1
Pull the rear end of
the shelf support
away from the side
wall and remove it.
5. When the display shows P1, press
start the procedure. You can use the
End function to delay the start of the
cleaning.
Pyrolytic procedure takes 2 hours.
Do not open the door before the
procedure completes. This will
abort the procedure. To prevent risk of
burns when the oven reaches a certain tem-
perature the door automatically locks. The
display shows the symbol
oven cools down, the door automatically
unlocks.
To stop Pyrolysis before it is comple-
ted, turn the knob for the oven func-
tions to the off position.
When Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked. When the appliance is cool again,
an acoustic signal sounds and the door un-
locks.
During the Pyrolysis the oven lamp is
off.
Cleaning reminder
To remind you that Pyrolysis is necessary,
PYR flashes in the display for 10 seconds
after each activation and deactivation of
the appliance.
The cleaning reminder goes off the
display:
• After the end of the Pyrolysis function
• If you press + and - at the same time
while PYR flashes in the display.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of
electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deac-
tivate the circuit breaker.
16
to
. When the
Друкувати сторінку