KitchenAid KFGS366VSS00 Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Варильна поверхня KitchenAid KFGS366VSS00. KitchenAid KFGS366VSS00 20 сторінок. 30" (76.2 cm) and 36" (91.4 cm) gas built-in cooktop
Також для KitchenAid KFGS366VSS00: Посібник з експлуатації (5 сторінок), Перелік деталей (5 сторінок)
Друкувати сторінку
Turn adjustment screw "C"totheright t oreduce f lame
height, turnadjustment screw tothelefttoincrease flame
height.
5. Tighten screw "A"toreduce f lame height. Loosen s crew to
increase flame height.
B
C
A. _z" (#0 [2.0 mm]) flat blade screwdriver
(screwdriver shaft must be a minimum of
1 _" (28.0 mm) long)
B. Control knob stem opening
C. Adjustment
screw location
4. Replace the control knob.
5. Test the flame by turning the control from LO to HI, checking
the flame at each setting
Adjustment for Dual Valve:
1. Set the inner crown flame to LO.
A
B
A. Adjustment screw - inner crown
B. Adjustment screw - outer crown
6. Replace the control knob.
7. Set the outer crown flame to LO.
8. Remove the control knob.
9. Tighten screw "B" to reduce flame height. Loosen screw to
increase flame height.
10. Replace the gray shield. Use a screwdriver to help push the
shield into place.
11. Replace the black rubber grommet.
12. Replace the control knob.
13. Test the flame by turning the control from LO to HI, checking
the flame at each setting.
If you need Assistance
or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your cooktop.
2=
3.
4.
A. Inner crown
B. Outer crown
Remove the control knob.
Remove the black rubber grommet.
Using needle-nose pliers, remove the gray shield inside the
burner valve opening.
..... A
A. Control knob
B. Black rubber grommet
C. Gray shield