Britax R032S Series Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Дитячі та ясельні меблі Britax R032S Series. Britax R032S Series 6 сторінок. Portable cot

1. TO OPEN THE COT

THESE STEPS WILL ENSURE THAT THE COT IS

CORRECTLY OPENED AND READY FOR USE.

Unzip the carry bag and remove the cot.

Stand the cot on its feet and undo the hook & loop

straps that hold the mattress around the frame.

Remove the mattress and set other accessories aside.

Separate the legs of the cot.

Starting with the short rails pull the centre up with

both hands quickly until they are locked in place.

(CAUTION: TAKE CARE, AS FINGER PINCHING CAN

OCCUR IN THE CORNERS WHEN LOCKING THE RAILS

IN PLACE.)

Now do the same with the longer rails.

NOTE: ALL THE TOP RAILS SHOULD BE LOCKED IN

PLACE. IF THEY ARE NOT, RELEASE THEM AND TRY

AGAIN. THE CENTRE OF THE COT BASE MUST

BE IN A RAISED POSITION TO ALLOW THE RAILS

TO LOCK EASILY. CHECK FOR THE SECURE

ENGAGEMENT OF THE RAILS BY PUSHING DOWN

ON THEM.

Holding one end of the cot clear of the ground, gently

press down the handle in the middle of the base until

the base lays down ﬂat. The base should now be

locked into position.

www.britax.com.au

5. TO USE THE CHANGETABLE (con't)

Pick the changetable up by the plastic hooks and

connect to the Portable Cot short end rail as shown.

Rotate the Changetable over the Portable Cot and

engage each of the four clamps onto the side rails.

Move the Bassinette clamps slightly if they interfere

with attaching the Changetable.

NOTE: MAKE SURE THE FOUR CLAMPS ARE ENGAGED

ON TO THE SIDE RAILS.

Pull the pocket ﬂap over the end of the Portable Cot.

Attach the plastic clamps to the leg tubes to keep the

pocket in place.

When the Changetable is not in use, always fold over

the end rail until required again.

To remove the Changetable, release the plastic hooks

from the top rails.