HIKVISION H1T Series Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Камера спостереження HIKVISION H1T Series. HIKVISION H1T Series 14 сторінок. Turbo hd dome camera
Також для HIKVISION H1T Series: Посібник користувача (15 сторінок), Посібник користувача (17 сторінок), Посібник користувача (17 сторінок), Посібник користувача (14 сторінок), Посібник користувача (14 сторінок)

2 Installation

Before you start:

 Make sure that the device in the package is in good

condition and all the assembly parts are included.

 Make sure that all the related equipment is power-off

during the installation.

 Check the specification of the products for the

installation environment.

 Check whether the power supply is matched with

your required output to avoid damage.

 Please make sure the wall is strong enough to

withstand three times the weight of the camera and

the mounting.

 If the wall is cement, insert expansion screws before

you install the camera. If the wall is wooden, use

self-tapping screw to secure the camera.

 If the product does not function properly, contact

your dealer or the nearest service center. Do NOT

disassemble the camera for repair or maintenance by

yourself.

2.1 Installation of Type I Camera

2.1.1 Ceiling/Wall Mounting without Junction Box

Steps:

1. Disassemble the turret camera by rotating the

camera to align the notch to one of the marks, as

shown in the figure below.

Figure 2-1 Disassemble the Camera

2. Remove the mounting base from the camera body

with a flat object, e.g., a coin.

3. Paste the drill template (supplied) to the place

where you want to install the camera.

4. Drill the screw holes and the cable hole (optional)

on the ceiling/wall according to the drill template.

Note:

Drill the cable hole when adopting the ceiling outlet to

route the cable.

5. Attach the mounting base to the ceiling/wall and

secure them with supplied screws

Figure 2-2 Drill Template

Mark

Notch