IKEA 504-660-01 Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Вентиляційна витяжка IKEA 504-660-01. IKEA 504-660-01 44 сторінки.
Також для IKEA 504-660-01: Посібник (36 сторінок)

Друкувати сторінку

Installation and connection

In the event of problems,

•

contact the Authorized Service

Centre. To prevent any damage,

only remove the appliance from

its packaging at the time of

installation.

Preparing for installation

WARNING: This is a heavy

product; the hood should only be

lifted and installed by two or more

people.

Electrical Requirements

Observe all governing codes and

ordinances.

Ensure that the electrical installa-

tion is adequate and in conformance

with National Electrical Code, ANSI/

NFPA 70 (latest edition), or CSA

Standards C22.1-94, Canadian Elec-

trical Code, Part 1 and C22.2 No.

0-M91 (latest edition) and all local

codes and ordinances.

If codes permit and a separate

ground wire is used, it is recom-

mended that a qualified electrician

determine that the ground path is

adequate.

A copy of the above code standards

can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

A 120 volt, 60 Hz., AC only,

•

15-amp, fused electrical circuit

is required.

If the house has aluminum wiring,

•

follow the procedure below:

Connect a section of solid

copper wire to the pigtail leads.

Connect the aluminum wiring

to the added section of copper

wire using special connectors

and/or tools designed and UL

listed for joining copper to alu-

minum.

Follow the electrical connector man-

ufacturer's recommended proce-

dure. Aluminum/copper connection

must conform with local codes and

industry accepted wiring practices.

Wire sizes and connections must

•

conform with the rating of the

appliance as specified on the

model serial rating plate.

The model/serial plate is located

behind the filter on the rear wall

of the range hood.

Wire sizes must conform to the

•

requirements of the National

Electrical Code, ANSI/NFPA 70

(latest edition), or CSA Standards

C22. 1-94, Canadian Electrical

Code, Part 1 and C22.2 No.

0-M91 (latest edition) and all

local codes and ordinances.

ENGLISH