ENGLISH
• To clean metal surfaces use a usual
cleaning agent.
• Clean the oven interior after each use.
Then you can remove dirt more easily
and it does not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all oven accessories after each use
and let them dry. Use a soft cloth with
warm water and a cleaning agent.
• If you have nonstick accessories, do not
clean them using aggressive agents,
sharp-edged objects or a dishwasher. It
can destroy nonstick coating.
Stainless steel or aluminium applian-
ces:
Clean the oven door with a wet sponge on-
ly. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive
materials, as they can cause damage to the
oven surface. Clean the oven control panel
with the same precautions.
Shelf supports
You can remove the shelf supports to clean
the side walls.
Removing the shelf supports
1
Pull the front of the
shelf support away
from the side wall.
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
2
2
1
Pull the rear end of
the shelf support
away from the side
wall and remove it.
Pyrolysis
Warning! The appliance becomes very
hot. There is a risk of burns.
Caution! If a hob is installed with the
appliance, do not use it at the same
times as the Pyrolysis function. It can cause
damage to the appliance.
1. Remove the removable shelf supports (if
applicable) and accessories from the
appliance. Refer to "Removing the shelf
supports".
Caution! Do not let the removable
shelf supports stay in the appliance
during the cleaning procedure. There is a
risk of damage.
2. Remove the worst dirt manually.
3. Fully close the oven door.
The cleaning procedure cannot start if
you do not close the oven door.
4. Set the function Pyrolysis. Refer to
"Oven functions".
5. When the display shows P1, press
start the procedure. You can use the
End function to delay the start of the
cleaning.
Pyrolytic procedure takes 2 hours.
Do not open the door before the
procedure completes. This will
abort the procedure. To prevent risk of
burns when the oven reaches a certain tem-
perature the door automatically locks. The
display shows the symbol
oven cools down, the door automatically
unlocks.
To stop Pyrolysis before it is comple-
ted, turn the knob for the oven func-
tions to the off position.
When Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked. When the appliance is cool again,
an acoustic signal sounds and the door un-
locks.
During the Pyrolysis the oven lamp is
off.
16
to
. When the
Друкувати сторінку