CeoTronics CT-DECT Base Інструкція з експлуатації Посібник з експлуатації - Сторінка 13

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Гарнітури CeoTronics CT-DECT Base. CeoTronics CT-DECT Base 14 сторінок. Headset for wireless duplex communication
Також для CeoTronics CT-DECT Base: Інструкція з експлуатації Посібник з експлуатації (20 сторінок), Інструкція з експлуатації Посібник з експлуатації (20 сторінок), Інструкція з експлуатації Посібник з експлуатації (14 сторінок), Інструкція з експлуатації Посібник з експлуатації (20 сторінок)

Recharging the batteries

CAUTION

Never use battery chargers to charge non-rechargeable batteries. Never open rechargeable

batteries or throw them into fire. Used (defective) rechargeable batteries are subject to special

waste disposal. Do not put them in the household refuse !

Use a CeoTronics charger (see section 11) to

charge the 3.6 V/600 mAh battery in the headset.

Using other chargers can cause rechargeable

batteries to become damaged. The charging time

of a battery is dependent on the charger you are

using. Separate CeoTronics operating instructions

are available for this purpose.

The battery charging socket (Fig. 5/b) is located

on the right-hand headset muff and is sealed with

a stopper (Fig. 5/a). Before connecting the

charger pull the stopper out of the battery

charging socket and re-insert it after recharging.

WARNING

To recharge the battery always switch off the headset (On/Off switch and volume control in

position »OFF«).

10.

Regularly examine the headset muffs and in particular the ear cushions for signs of fractures, cracks

and wear. If the headset muffs are damaged, replace them and send them in to CeoTronics for repair.

Replace damaged or worn ear cushions in accordance with section 10.4, and, even if not damaged,

every 6 months of use at the latest.

WARNING

When cleaning ensure that no moisture penetrates inside the unit. Do not use any solvents

(e.g. benzine, alcohol, etc.) for cleaning purposes !

Remove any loose dust with a soft brush. Clean, if necessary, the outside with a suitable clean cloth

that has been slightly moistened with clear water, and rub the parts dry afterwards. If heavily soiled,

some dishwashing liquid can be used in addition.

Fig. 5