IKEA HARMONISK Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Вентиляційна витяжка IKEA HARMONISK. IKEA HARMONISK 16 сторінок. Harmonisk
Також для IKEA HARMONISK: Посібник користувача (16 сторінок), Посібник (48 сторінок)

Друкувати сторінку

ENGLISH

To activate the alarm, disable the

electronic by touching the

3 seconds.

Next, simultaneously touch buttons

and

for 3 seconds until hearing the

sound signal: at first, only LED 1 will

flash and then both LEDs 1 and 2 will

flash to indicate the activation. Repeat

the procedure to deactivate the alarm:

at first, LED 1 and 2 will flash and

subsequently only LED 1 to indicate

deactivation. If you touch simultaneously

buttons

and

Cleaning and maintenance

WARNING:

- Never use steam cleaning equipment.

- Disconnect the appliance from the

power supply.

IMPORTANT: do not use corrosive or abrasive

detergents. If any of these products accidentally

comes into contact with the appliance, clean

immediately with a damp cloth.

•

Clean the surfaces with a damp cloth.

If it is very dirty, add a few drops of

washing up detergent to the water.

Finish off with a dry cloth.

IMPORTANT: do not use abrasive sponges

or metallic scrapers or scourers. Over time,

these can ruin the surface.

•

Use detergents specifically designed for

cleaning the appliance and follow the

manufacturer instructions.

IMPORTANT: clean the filters at least monthly

to remove any oil or grease residuals.

Perimeter suction panel

The suction panel must be cleaned with the

same frequency as the grease filter. Use a

damp cloth and a soft liquid detergent.

Do not use products containing abrasives.

DO NOT USE ALCOHOL

The panel normally covers the grease filters,

button for

for 1 second you

can verify which filter alarm mode is

activated: LED 1 flashing alone for

grease filter alarm mode, or LEDs 1 and

2 flashing for grease filter and carbon

filter alarm mode.

HIGH-SPEED BUTTON (suction power).

INTENSIVE SPEED BUTTON (suction

power) - duration 5 minutes - touch

again to return to previous setting.

LIGHT BUTTON ON/OFF

and must therefore be opened each time

access to the grease filters and the inside

of the hood is required (e.g. to replace the

carbon filters).

Opening: Pull the panel downwards.

Closing: The panels must be fixed to the

appropriate pins on the surface of the hood.

WARNING: Always check that the panel is

fitted properly.

To clean the grease filter

The metal grease filter has an unlimited life

and must be washed once a month by hand

or dishwasher at low temperature and with

a short cycle. With cleaning in a dishwasher

the grease filter may become dull; this does

not effect its filtering capacity.

Grease filter maintenance:

1. Disconnect the hood from the electric

power supply.

2 Remove the grease filters: pull the spring

release handle downwards, then remove

the filter.

3. After cleaning the grease filter, remount

in reverse order ensuring the entire

extraction surface is covered.

The front side is indicated by the writings

"Front" printed on the hidden side of the

panel.