3.2
Commissioning
3.2.1 Fasten the CT-DECT Multi (PP) on your clothing
Fasten the CT-DECT Multi at a suitable place on your clothing. Take care that your mobility is not im-
paired and the CT-DECT Multi (PP) can be operated without any problem.
3.2.2 Connect the headset to the CT-DECT Multi (PP)
Put the headset on. Fasten the PTT button of the headset with the clip on its back side at a suitable
place on your clothing. Connect the PTT button with the 6-pin connector through the connecting cable
to the 6-pole jack of the CT-DECT Multi (PP).
3.2.3 Switch on CT-DECT Multi (PP) and CT-DECT Case (8) (FP)
Switch-on, establishing connection, adjusting the volume
PLEASE NOTE:
Applies to CT-DECT Multi (PP) units subscribed to a CT-DECT Case (8) (FP).
a. First switch on the CT-DECT Case (8) (FP). The CT-DECT Case (8) (FP) starts now an initialization
process during which it may not be switched off. After initialization the pilot lamp lights up.
b. Switch on the CT-DECT Multi (PP) units you want to communicate with, using the ON/OFF switch /
volume control. After switch-on you will hear a high beep in the headsets. After this, synchronization,
i.e. the search process, starts between the CT-DECT Case (8) (FP) and the CT-DECT Multi (PP)
units, the duration of which may vary. While this process is under way, a high-low tone sequence will
be heard every second in the CT headsets, indicating, that the CT-DECT Multi (PP) units are seek-
ing their CT-DECT Case (8) (FP).
After successful synchronization - i.e. a CT-DECT Multi (PP) found its CT-DECT Case (8) (FP) - the
high-low tone sequence falls silent and a high double beep is heard in the headset. CT-DECT Case (8)
(FP) and CT-DECT Multi (PP) units establish now automatically the connection between one another.
As soon as the connection is established a final high beep will be heard in the CT headset. This indi-
cates that the units are now ready for duplex communication within the working range between CT-
DECT Multi (PP) and base unit.
14
Друкувати сторінку