KitchenAid Pro Line KGCP467J Інструкція з монтажу Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Варильна поверхня KitchenAid Pro Line KGCP467J. KitchenAid Pro Line KGCP467J 12 сторінок. Pro line series 36" and 48" gas cooktop, for residential use only
Також для KitchenAid Pro Line KGCP467J: Посібник з розмірів (1 сторінок)
Gas an
E!
c
Basso
imensions
Gassopply lineshould be
located ir_thisareaoerearor
side
wails,or the
supply
line cue
comeup
tbrougb
tbeflooL
Gas and Emectric
Connection
Locations
productrating/serial tag
control supt_
panel
regulator (
with product)must be
#_stalled with arrow up
pohltieg at cooktop
bottom
1/2" nipple
(nat supplied)
AGA or CSA approved
flexible stainless
steel gas supply line
(not supplied)
36" (91.4 era)
3=preeggroued=type
power supply cord
Front of
Cooktop
Typical
Gas and Electric
Connections
Copies of the standards listed may be
obtained from:
* CSA Internationa{
8801 East Pleasant Valley Rd,
Cleveland,
Ohio 44131o5878
Explosion
Hazard
Use a new AGA or CSA approved
gas supply
line.
Install a shut=off valve.
Securely tighten
aH gas
connections.
If connected
to LP, have a
qualified
person make sure gas
pressure
does not exceed 14"
water column.
Examples
of a quamified person
inctude licensed heating
personnel,
authorized
gas
company
personnel,
and
authorized
service personnel
Failure to do so can result in
death, explosion,
or fire.
Observe at1governing
codes and
ordinances,
Important:
Cooktop must be connected
to a regulated gas suppiyo
Am
This installation must conform with
local codes and ordinances. In the
absence of local codes, installations must
conform with American National
Standard, National Fuel Gas Code
ANSI Z223.1 -- latest edition or
CANI -- B149.1 or 2".
minput ratings shown on the
model/serial rating plate are for elevations
up to 2,000 feet (610 m). For elevations
above 2,000 feet (610 m), ratings are
reduced at a rate of 4% for each 1,000
feet (305 m) above sea level.
raThe cooktop is equipped for use
with NATURAL gas. It is design-certified
by International Approval Services (I.A.S.)
for NATURAL and LR gases with
appropriate conversion. The model/serial
rating plate, located on the underside of
the burner box, has information on the
type of gas that can be used. if this
information does not agree with the type
of gas available, check with the local gas
supplier.