Green Power LEGRAND ZLGP16 Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Вивіз сміття Green Power LEGRAND ZLGP16. Green Power LEGRAND ZLGP16 2 сторінки.

Друкувати сторінку

Wireless and batteryless Wake Up/Sleep control

0 648 84L/85L - 0 677 86L

0 770 57L - 6 000 84L

5 742 87/93 - 5 743 22 - 5 748 36

7 418 03L/33L/63L

Requires to install the connected starter pack and one or more «... with Netatmo» connected switch, micromodule

or socket outlet

Module Control

Pack contents:

Wake Up/Sleep control

Stickers

Setup button

Pair the wireless, batteryless switch to your connected installation.

Make sure that the indicator lights on the wired products are green and not ashing.

If not, go back to step

wired product ashes rapidly.

For the speci c case of the latching relay, press the main button of the latching relay until the con guration indicator

ashes slowly in blue, release it then tap it 3 times with the wireless, batteryless "Wake Up/Sleep control". The indicator

light of the wired product ashes rapidly.

While holding the "setup" button on the wireless, batteryless control, brie y press the "Wake Up" or "Sleep" control on the

wireless batteryless control.

The indicator light of the wired product will brie y turn blue, and then will turn green again.The pairing was successful.

Complete the con guration of the scenarios using your HOME + CONTROL application, menu "Settings", then

"Scenarios"

Complete the installation

< 1 s

To complete your installation,

ration of the Module Control or the middle of the wire-

less Home / Away master switch.

Gateway power outlet and home/away wireless

master switch

Wake Up

Sleep

Frequency bands: 2.4 - 2.4835 GHz

Power level: < 100 mW

Do not remove

the cover plate

batteryless control (factory reset)

< 1 s

While holding the "setup" button on the wireless batteryless

control, press the "Wake Up" button for 5 seconds.

Check that your control is correctly reset by making an

"Wake Up" command, then "Sleep"

Start the con guration

Press the con guration button of Module Control or press the middle of the wireless master switch (with battery)

until its light brie y turns green, and then stop pressing. All wired products lights will turn green.

> 3 s

www.legrandoc.com/064884L

LEGRAND - Pro and Consumer Service - BP 30076

87002 LIMOGES CEDEX FRANCE • www.legrand.com

Download the app

Your installation is ready. You can download the Legrand Home +

Control application to control your lights remotely.

FCC ID: 2ACN8-ZLGP1X

Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) This device

must accept any interference, including interference that may cause undesired operation of the device.

ration distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

to operate the equipment.

FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

5 s

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Consult the dealer or an experienced radio/TV technician for help.

Safety instructions

Make sure the power supply is disconnected before any intervention.

Strictly comply with instructions for installation and use.

Put the stickers in place

Before xing the wireless control(s) with

the removable stickers provided, test one

on a non-visible area of the wall.

H < 2 m

H > 2 m

You can also x the wireless control(s) permanently to the

wall with screws.

The undersigned, Legrand declares that the radio-electric equipment type

(0 648 84L/85L - 0 677 86L - 0 770 57L - 6 000 84L - 5 742 87/93 - 5 743 22 -

5 748 36 - 7 418 03L/33L/63L)

complies with directive 2014/53/EU. The full text of the EU declaration of

conformity is available on the following website: www.legrandoc.com

IC: 12132A-ZLGP1X

Model : ZLGP16

Model: ZLGP16