Decor Star PL-004-SS-TB Інструкція з монтажу Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Сантехніка для ванної кімнати Decor Star PL-004-SS-TB. Decor Star PL-004-SS-TB 12 сторінок.

Друкувати сторінку

Maintenance Guide

Please follow the cleaning material manufacturer's instructions. In addition, pay attention to the

following points:

1. Regular cleaning can prevent mineral build up on shower head and handheld shower.

2. Use a mild detergent such as liquid dishwashing soap and warm water for cleaning.

3. Do not use abrasive / harsh chemical when cleaning the fi xture as they will damage and dull the

fi nish.

4. Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.

5. Test the cleaner on a small area before using on the entire surface.

6. Do not leave the cleaner on the fi xture longer than necessary.

7. When using spray cleaners, spray fi rst onto a soft cloth or sponge. Never spray directly onto the

faucet as droplets can enter openings and gaps and cause damage.

8. After cleaning, rinse thoroughly with clean water to remove any cleaner residue.

Troubleshooting

NOTE: To maintaine the performance of the shower panel. The thermostatic valve needs to be cleaned at least once a

year. More frequent cleaning is needed if water has high mineral content.

NOTE: Proper pressure must be maintained for the thermostatic valve to work properly. Make sure water pressue is about

the same on both hot and cold water side.

1. Water is Either Only Hot or Only Cold

Solution: If the newly installed shower panel fails to regulate temperature, the fi rst step is to check the water supply hoses.

The thermostatic valve will not work if the hoses are installed backward. Contrary to common plumbing belief, it does

matter which side they are installed, as the valve has a hot side and a cold side. If the hoses were installed in reverse,

you should simply switch the hoses back. Also check for dirt or sediments in the check valves. Sometimes dirt can

inadvertently lodge in the check valve making it not to open therefore cutting off water fl ow to the unit. The check valves

can be cleaned by cotton swabs. Make sure the check valves are free of dirt and operate as normal.

2. Failure to Mix Hot and Cold water

Solution: The fi rst thing to check is the water pressure at both inlets. The water pressure should be equal for both hot

and cold water side. The thermostatic valve will not work properly if there is a lack of water pressure due clog, damaged

shutoff valve, or damaged check valve. The pressure issue will needs to be resolved before the valve can operate

properly. Unbalanced water pressure will make it harder to achieve desired water temperature. The water will be either too

hot or too cold.

3. Water Temperature is Either Too Hot or Too Cold

Solution: If proper water pressure is maintained but the panel is not able to maintain desired water temperature. The

thermostatic valve may also needs to be recalibrated. Please follow the calibration instruction in this installation guide.

4. Low Water Pressure / Flow

Solution: Any restrictions in the water supply hoses will greatly reduce the performance of the shower panel. The fi rst step

is to make sure both shut-off valves are fully open. Secondly, check the water supply hoses for kinks. Due to limited space

behind the shower panel, the hoses can get kinked very easily. Make sure the hoses are free of kinks when hanging the

shower panel on the wall. Lastly, make sure both check valves are working properly. A malfunctioned check valve can also

cause low water fl ow to the thermostatic valve. The check valve should open when the center is pushed with tip of a pen

or a cotton swab. The check valve should close automatically when no external pressure is applied to the center part of

the valve.

Decor Star

PL-004-SS-TB Rev. C 022018