Green Power HFC 5-15 Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Зарядний пристрій Green Power HFC 5-15. Green Power HFC 5-15 4 сторінки. Multiple lead acid battery charger
Друкувати сторінку
IMPORTANT SAFETY INSTRUCTIONS (DO'S AND DON'TS):
BEFORE PROCEEDING FURTHER KINDLY GO THROUGH THE SAFETY INSTRUCTIONS
1.
CONNECT TO MAINS SUPPLY & CONNECT THE OUTPUT WIRES TO THE BATTERY AND THEN POWER
ON THE INPUT SWITCH. INPUT POWER WIRING SHALL BE FOR MINIMUM 16 AMP.
2.
THE BATTERY BANK SHALL BE PROPERLY INTERCONNECTED WITH RATED WIRE & THE TERMINAL
CONNECTION POINTS SHALL BE CLEAN.
3.
BATTERY BANK VOLTAGE SHALL BE WITHIN 8 V TO 82.5 V
4.
DO NOT INSTALL THIS CHARGER ON OR NEAR FLAMMABLE
AND GASOLINE ETC.).
5.
PLACE THE CHARGER ON ITS WALL HANGING ARRANGEMENT OR ON THE FOOT REST. KEEPING
UPWARD DIRECTION. DO NOT KEP IT HORIGENTALLY.
TAKE IT TO OUR SERVICE CENTRE IN CASE OF ANY MALFUNCTION AND OR IF ANY SERVICE IS REQUIRED.
OPENING BY UNQUALIFIED PERSONNEL CAN RESULT ELECTRIC SHOCK OR FIRE HAZARD. OPENING OF
THE UNIT EXCEPT BY OTHER THAN SIGNOTRON ENGINEER WILL LEAD TO CANCELLATION OF THE
GUARANTEE OF THE PRODUCT.
TROUBLE SHOOTING
(IF THE CHARGER IS NOT CHARGING THE BATTERY BANK FOLLOW THE LED INDICATIONS TO FIND THE
ROOT CAUSE AND RECTIFY)
SYMPTOMS
MAINS ON LED OFF
NO / REV. BATTERY GLOWING
CHARGING ON
CHARGER FAULT LED GLOWING
PROBLEM
1.
WIRING PROBLEM OR INPUT
SWITCH OFF.
2.
LOOSE CONNECTION / NO VOLTAGE
AT PLUG POINT.
3.
INPUT FUSE BLOWN
BATTERY CONNECTION WRONG
CHARGING PROCESS IS ON. IN CASE IT
GETS OFF PLEASE CHECK LCD DISPLAY
INPUT SUPPLY VOLTAGE OUT OF RANGE
OR INTERNAL TRIP
MATERIALS (PLYWOOD, CHEMICALS
REMEDY
1.
CHECK WIRING & ON INPUT
SWITCH
2.
CHECK INPUT VOLTAGE AND
CHECK ALL CONNECTION.
CHECK AC FUSE
3.
CHECK THE BATTERY BANK VOLTAGE SHALL
BE > 8 V ALSO CHECK BATTERY BANK
WIRING
ACT AS PER LCD DISPLAY GUIDANCE
MAKE THE INPUT SWITCH OFF AND ON
AFTER A DELAY OF FEW SECONDS