Decora Sunwood Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Віконні жалюзі Decora Sunwood. Decora Sunwood 2 сторінки. Basswood solid timber venetian blinds
Друкувати сторінкуSunwood 50mm Basswood- Solid Timber Venetian Blinds
Reduce risk of strangulation to infants and toddlers.
Position safety cord-stops before using blinds.
TO POSITION SAFETY CORD-STOPS:
Cord-Stop
Headrail
2.5-5 cm
Cord-Stop
Headrail
2.5-5cm
(Note: Use of hold down bracket is recommended to fully utilise the safety
feature of the cord-stops)
1. When opening or closing blind only raise or lower the blind
when the slats are in the horizontal (open) position. Larger blinds
must be raised or lowered in stages. Raising or lowering in one
singular motion places excessive stress on the mechanism, strings
and brackets.Do not force the cord when tilting the blinds, this may
cause the mechanism to break.
2. It is not recommended that wooden blinds be fitted in damp or
wet environments as warpage may occur.
3. Dust blinds regularly.
WARNING
1. Install blind as directed
Headrail
by manufacturer making
sure headrail is securely
fastened. Lower blind to
maximum desired length
and lock into place.
2. Measure the distance
from headrail to cord-stops.
If cord-stops are 2.5cm to
5cm below the headrail
no further adjustment is
needed. Your blind is ready
to be used.
3. If cord-stops ARE NOT
2.5cm to 5cm below
headrail loosed (but do not
untie) the knot surrounding
the cord-stop.
4. Push both the cord-stop
and the loosened knot
toward the headrail until
the cord-stop is 2.5cm to
Cord-Stop
5cm below the headrail.
Hold cord-stop in place and
pull firmly on lift cord to re-
tighten knot. Repeat steps
2, 3 & 4 for each cord-stop.
RECOMMENDED CARE FOR WOODEN BLINDS
SAFETY CLEAT FITTING INSTRUCTIONS
STEP 1
• Place safety cleat in the desired location on the wall and
mark the position of the two holes using a pencil.
• We recommend position the cleat to either side of the blind
and out of the reach of children
STEP 2
• Remove the safety cleat and drill the
position marked Once the holes are
drilled place a rawplug into the holes
• Use the screws provided to attach the
safety cleat to the wall
STEP 3
• We recommend that the cord is wrapped around the safety
cleat when the blind is not in use, as shown in the pictures
below.
4. If the blind becomes damp or wet, wipe down immediately.
The slats should be horizontal (open) and the blind released and
lowered completely. Allow to dry by removing the blinds from the
brackets and lay down on a hard surface. Do not place in direct
sunlight as excessive heat may cause the slats to warp. If the blinds
are excessively wet do not place the blinds on a surface that may
absorb any stain.
5. This wooden blind does not require any oiling.
If you have any doubts about the care or maintenance of your wood-
en blind do not hesitate to contact your nearest supplier for advice.