DecoRad HandMate UV600 Короткий посібник - Сторінка 2
Переглянути онлайн або завантажити pdf Короткий посібник для Електроінструмент DecoRad HandMate UV600. DecoRad HandMate UV600 2 сторінки. Ultimate tool for instantly curing uv (floor) coatings
Також для DecoRad HandMate UV600: Посібник користувача (17 сторінок)
Друкувати сторінкуIMPORTANT !
ALWAYS cool a HOT UV lamp
NEVER start up a HOT UV lamp.
Quickguide Handmate UV 600 v. 2.5
Press the button with the lamp symbol
in order to start up the UV lamp.
On the display of the lamp unit the text
WAIT will be shown
The UV lamp needs 60 seconds to
warm-up
When DIM is shown in the display, the
HandMate UV 600 is ready to use
Use the button on the lampunit or the
extension handle to start UV curing
The shutter opens
On the display of the lamp unit the text
FULL will be shown
Full power UV can only be used in the
safe range of 2 – 10 centimeters to any
surface
DIST shown in display = distance to
surface is not correct / unsafe, a
beeping signal can be heard and the
shutter closes.
Move the lamp unit in a position
between 2 – 10 centimeters from the
surface
Switch off the UV lamp to end curing .
The text COOL will be shown.
Leave the HandMate UV 600 connected
for min. 1 minute to cool down. Leave the
HandMate UV 600 for 2 minutes to cool
Press the (power) OFF button
ERROR MESSAGES CHECK MANUAL
E14 LAMP OVERHEATED
E15 FAN FAIL
E16 SHUTTER FAIL
E17 TEMPERATURESENSOR FAIL
U51 DISTANCE TO SUBSTRATE
U94 TIME MANAGEMENT 5 MINUTES