IKEA DISKAD Інструкція з експлуатації - Сторінка 29

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Посудомийна машина IKEA DISKAD. IKEA DISKAD 50 сторінок.
Також для IKEA DISKAD: Посібник (36 сторінок), Посібник (16 сторінок), Посібник (45 сторінок), Посібник (37 сторінок)

Друкувати сторінку
IKEA DISKAD Інструкція з експлуатації

Switching on the appliance

Turn tap fully on.
1.
Switch on ON/OFF switch (.
2.
The Eco 50° programme has been
preset for environmentally friendly
operation whenever the appliance
starts. This programme remains
selected if no other programme
button 0 is pressed.
Press START button `.
3.
Programme sequence starts.
Note:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° program is a particularly
environmentally friendly program and
well-suited for normally soiled
tableware. It is the most efficient
program in the combination of energy
and water consumption for this type of
conformity with the tableware and
content of the EU European Ecodesign
Directive.
Operating the appliance en
Optical display while a
programme is running *
* depending on the configuration of
O p t i c a l d i s p l a y w h i l e a p r o g r a m m e i s r u n n i n g
your specific dishwasher
While a programme is running, a light
spot is projected onto the floor at the
bottom of the dishwasher door. Do not
open the dishwasher door until the light
spot is no longer visible on the floor. If
the door is not properly closed the light
spot will flash.* If the appliance is
installed at eye-level flush with the
furniture, this display will not be visible.
Here's how to change the setting:
Switch on ON/OFF switch (.
1.
Hold down the programme button
2.
# and then repeatedly press the
START button ` until : ....
appears in the display window.
Release both buttons.
3.
The LED of the # button flashes
and the display window h lights
up to show the value : ...
Press the programme button #
4.
repeatedly until the factory setting
value :
appears in the display
window h.
Press the 3 button to switch the
5.
function on :
Press START button `.
6.
The set value is saved.
Remaining running time
display
When the programme is selected, the
remaining programme time is indicated
in the display window h.
The running time is determined during
the programme by the water
temperature, the quantity of dishes as
well as the degree of soiling and may
vary (depending on the selected
programme).
or off
:
.
29