IKEA IUD9500VX0 Інструкція з монтажу Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Посудомийна машина IKEA IUD9500VX0. IKEA IUD9500VX0 40 сторінок. Undercounter dishwasher plastic giant tubmodels
Також для IKEA IUD9500VX0: Інструкція користувача (20 сторінок)
Друкувати сторінку
3. Run wireintohouse w iring junction b ox.
4. Install aUL-listed/CSA-certified
clamp connector (strain r elief)
forflexible-type
wire. I finstalling conduit, attach a UL-listed/
CSA-certified
conduit connector tothejunction b ox.
5. Run other e nd ofwire through c abinet hole. C able m ust
extend t otheright f ront o fcabinet opening.
A
A. Direct wire
Option 2: Power Supply Cord Method
NOTE: A mating, 3-prong, grounded-type
wall receptacle is
required in a cabinet next to the dishwasher opening.
1. Drill a 1W' (3.8 cm) hole in the cabinet rear or side. Preferred
and optional locations are shown.
A
B
2=
A. Optional locations
B. Preferred locations
Wood cabinet: Sand hole until smooth.
Metal cabinet: Cover hole with grommet
(Part Number 302797) included with power supply cord kit.
Install the Water Line
Helpful Tip: Routing the water line through the left side of cabinet
opening will make water connection easier.
1. Drill a minimum 1/2"(1.3 cm) hole in the cabinet side, rear or
floor. Preferred and optional locations are shown.
A
B
A. Optional locations
B. Preferred locations
2. Measure overall length of copper tubing required.
3. Attach copper tubing to the water line with a manual shutoff
valve.
A. Copper tubing
4=
Slowly feed copper tubing through hole in cabinet. Copper
tubing will bend and kink easily, so be gentle. The copper
tubing should be far enough into the cabinet opening to
connect it to dishwasher inlet on the front left of the
dishwasher.
5. Turn water shutoff valve to "ON" position. Flush water into a
shallow pan to get rid of particles that may clog the inlet valve.
6. Turn shutoff valve to "OFF" position.
Install the Drain Hose
IMPORTANT: Always use a new drain hose even when installing a
new replacement dishwasher.
1. Drill a 11/2"(3.8 cm) diameter hole in the cabinet wall or floor on
the side of the opening closest to the sink.
2. Connect drain hose to waste tee or waste disposer using one
of the following methods:
•
Option 1, Waste disposer-
with air gap
•
Option 2, No waste disposer-
with air gap
•
Option 3, Waste disposer-
no air gap*
•
Option 4, No waste disposer-
no air gap*
*An air gap is recommended.
Helpful Tip: To reduce the vibration of the hose, keep the hose
away from the floor and the edge of the hole where it passes
through the cabinet.
8