IKEA RENGORA Посібник користувача - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина IKEA RENGORA. IKEA RENGORA 48 сторінок. Ikea dishwasher
Також для IKEA RENGORA: Посібник користувача (24 сторінок), Посібник (24 сторінок), Посібник (28 сторінок), Посібник (32 сторінок), Інструкція з монтажу Посібник з монтажу (16 сторінок), Посібник (28 сторінок), Посібник (12 сторінок), Інструкція з експлуатації (29 сторінок), Посібник (29 сторінок)

Друкувати сторінку

ENGLISH

Problem and alarm code

The appliance does not fill with water.

• The end indicator flashes 1 time in-

termittently.

• Acoustic signal sounds 1 time inter-

mittently.

The appliance does not drain the wa-

ter.

• The end indicator flashes 2 times

intermittently.

• Acoustic signal sounds 2 times in-

termittently.

The anti-flood device is on.

• The end indicator flashes 3 times

intermittently.

• Acoustic signal sounds 3 times in-

termittently.

The salt indicator continues to stay on

after the replenishment of the salt

container.

Once you have checked the appliance,

deactivate and activate the appliance. If

the problem occurs again, contact an

Authorised Service Centre.

The washing and drying results are not satisfactory

Problem

There are whitish streaks or

bluish layers on glasses and

dishes.

• Make sure that the water tap is open.

• Make sure that the pressure of the water sup-

ply is not too low. For this information, contact

your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not

clogged. Clean the filter.

• Make sure that the inlet hose has no kinks or

bends.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or

bends.

• Close the water tap and contact an Authorised

Service Centre.

• If after 3 or 4 programmes, the salt indicator

continues to stay on, contact an Authorised

Service Centre.

This can occur when you are using salt that

needs more time to dissolve.

There in no unwanted effect on the perform-

ance of the appliance.

For alarm codes not described in the table,

contact an Authorised Service Centre.

• The release quantity of rinse aid is too much. Adjust

the rinse aid selector to a lower position.

• The quantity of detergent is too much.

Possible solution