ENGLISH
How to set the programme selection mode
The appliance is in programme selection
mode when only the indicator of the
programme
After activation, the appliance is in
programme selection mode by default. If
not, set the programme selection mode the
following way:
Press and hold simultaneously
until the appliance is in programme
selection mode.
The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the rinse
aid indicator is turned on notifying to refill
rinse aid. If the drying results are
satisfactory while using multi-tablets only, it
is possible to deactivate the notification for
refilling rinse aid. However, for best drying
performance, always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid empty
notification
Press the on/off button to switch the
appliance on.
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
indicators
,
2. Press
.
is on.
and
and
until the
and
start to flash.
• The indicators
• The indicator
• The indicator
setting:
empty notification is on.
3. Press
to change the setting.
•
is off = the rinse aid empty
notification is off.
4. Press the on/off button to confirm the
setting.
The appliance is now off.
Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is complete. This
acoustic signal is activated by default and
you can deactivate it.
When you press the main switch to turn on
the dishwasher, it makes a short beep
sound. The beep is activated by default and
you can deactivate it along with the
acoustic signal for the end of a programme.
How to deactivate the acoustic signal for
the end of programme
Press the on/off button to switch the
appliance on.
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
indicators
,
2. Press
.
• The indicators
• The indicator
and
go out.
continues to flash.
shows the current
is on = the rinse aid
and
until the
and
start to flash.
and
go out.
continues to flash.
11
Друкувати сторінку