IKEA RENGORA Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Посудомийна машина IKEA RENGORA. IKEA RENGORA 29 сторінок. Ikea dishwasher
Також для IKEA RENGORA: Посібник користувача (24 сторінок), Посібник користувача (48 сторінок), Посібник (24 сторінок), Посібник (28 сторінок), Посібник (32 сторінок), Інструкція з монтажу Посібник з монтажу (16 сторінок), Посібник (28 сторінок), Посібник (12 сторінок), Посібник (29 сторінок)

Друкувати сторінку
IKEA RENGORA Інструкція з експлуатації
WATER HARDNESS TABLE).
Water Hardness Table
Level
ENGLISH
1
Soft
2
Medium
Filling the rinse aid dispenser
3
Average
Rinse aid makes dish DRYING easier. The rinse aid dispenser A
4
Hard
should be filled when the RINSE AID REFILL indicator light
the control panel is lit.
5
Very hard
• Switch off the appliance by pressing the ON/OFF button.
Setting is complete!
Make sure the cap is screwed on tightly, so that no detergent can
get into the container during the wash program (this could damage
FILLING THE RINSE AID DISPENSER
the water softener beyond repair).
As soon as this procedure is complete, run a program without
loading. The "Pre-Wash" program alone is NOT
should be filled when the RINSE AID REFILL indicator light
Make sure the cap is screwed on tightly, so that no detergent can
Residual saline solution or grains of salt can lead to corrosion,
get into the container during the wash program (this could damage
irreparably damaging the stainless steel components.
B
B
the water softener beyond repair).
The guarantee is not applicable if faults are caused by such
As soon as this procedure is complete, run a program without
1. Open the dispenser
circumstances.
B
loading. The "Pre-Wash" program alone is NOT
the lid.
Residual saline solution or grains of salt can lead to corrosion,
2. Carefully introduce the rinse aid as far as the maximum (110
irreparably damaging the stainless steel components.
heating element may be damaged as a result.
ml) reference notch of the filling space - avoid spilling it. If this
The guarantee is not applicable if faults are caused by such
Whenever you need to add salt, it is mandatory to complete
happens, clean the spill immediately with a dry cloth.
circumstances.
the procedure before the beginning of the washing cycle.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the tub.
SETTING THE WATER HARDNESS
heating element may be damaged as a result.
To allow the water softener to work in a perfect way, it is essential
Whenever you need to add salt, it is mandatory to complete
Adjusting the dosage of rinse aid
that the water hardness setting is based on the actual water hard-
B
the procedure before the beginning of the washing cycle.
If you are not completely satisfied with the drying results, you
ness in your house. This information can be obtained from your local
can adjust the quantity of rinse aid used.
water supplier. The factory setting is for average (3) water hardness.
SETTING THE WATER HARDNESS
• Switch the dishwasher on using the ON/OFF button.
To allow the water softener to work in a perfect way, it is essential
• Switch on the appliance by pressing the ON/OFF button.
(110 ml) reference notch of the filling space - avoid spilling it.
• Switch it off using the ON/OFF button.
that the water hardness setting is based on the actual water hard-
• Switch off the appliance by pressing the ON/OFF button.
• Press button
three times - a beep will be heard.
ness in your house. This information can be obtained from your local
• Hold down button
for 5 seconds, until you hear a beep.
• Switch it on using the ON/OFF button.
water supplier. The factory setting is for average (3) water hardness.
• Switch on the appliance by pressing the ON/OFF button.
NEVER pour the rinse aid directly into the tub.
•
The current selection level number and the salt indicator light
• The current selection level number and rinse aid indicator
• Switch on the appliance by pressing the ON/OFF button.
light flash.
• Switch off the appliance by pressing the ON/OFF button.
•
Press button
to select the desired hardness level (see
• Press button
to select the level of rinse aid quantity to be
• Hold down button
for 5 seconds, until you hear a beep.
WATER HARDNESS TABLE).
supplied.
• Switch on the appliance by pressing the ON/OFF button.
Water Hardness Table
•
The current selection level number and the salt indicator light
• Switch it off using the ON/OFF button.
Setting is complete!
Level
•
Press button
to select the desired hardness level (see
German degrees
If the rinse aid level is set to ZERO (ECO), no rinse aid will be
WATER HARDNESS TABLE).
1
Soft
supplied. The LOW RINSE AID indicator light will not be lit if you
Water Hardness Table
2
Medium
run out of rinse aid. A maximum of 5 levels can be set according
3
Average
Level
to the dishwasher model. The factory setting is specific to the
German degrees
model, please follow instruction above to check this for your
4
Hard
1
Soft
machine.
5
Very hard
2
Medium
• If you see bluish streaks on the dishes, set a low number (1-2).
3
Average
• If there are drops of water or limescale marks on the dishes,
• Switch off the appliance by pressing the ON/OFF button.
Setting is complete!
set a high number (3-4).
4
Hard
5
Very hard
FILLING THE RINSE AID DISPENSER
• Switch off the appliance by pressing the ON/OFF button.

Control panel

should be filled when the RINSE AID REFILL indicator light
Setting is complete!
FILLING THE RINSE AID DISPENSER
should be filled when the RINSE AID REFILL indicator light
1
2
3 4
B
On-Off/Reset button with indicator light
1
(110 ml) reference notch of the filling space - avoid spilling it.
Program selection button
2
B
Salt refill indicator light
3
NEVER pour the rinse aid directly into the tub.
Rinse Aid refill indicator light
4
(110 ml) reference notch of the filling space - avoid spilling it.
Program number and delay time indicator
5
Tablet indicator light
6
NEVER pour the rinse aid directly into the tub.
°dH
German degrees
French degrees
0 - 6
7 - 11
12 - 17
18 - 34
35 - 50
1
2
1.
On-Off/Reset button with indicator light
2.
Program selection button
3.
Salt refill indicator ligh
4.
Rinse Aid refill indicator ligh
A
A
5.
Program number and delay time indicator
6.
Tablet indicator light
by pressing and pulling up the tab on
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the
retaining elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the
dishes andon the machine's functional components.
• It is important that the salt reservoir be never empty.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the
dishwasher (see PRODUCT DESCRIPTION) and should be
filled when the SALT REFILL indicator light
control panel is lit .
°dH
°fH
French degrees
0 - 6
0 - 10
7 - 11
11 - 20
°dH
°fH
12 - 17
21 - 30
French degrees
18 - 34
31 - 60
0 - 6
0 - 10
35 - 50
61 - 90
7 - 11
11 - 20
12 - 17
21 - 30
18 - 34
31 - 60
35 - 50
61 - 90
h
5
6
8
9
10
7
To download the full version visit www.ikea.com
°fH
0 - 10
11 - 20
Filling the detergent dispenser
21 - 30
Usage of detergent not designed for dishwashers may cause
31 - 60
malfunction or damage to the appliance.
in
61 - 90
To open the detergent dispenser press button C.
Introduce the detergent into the dry dispenser D only.
Place the amount of detergent for
3 4
5
6 7 8
9
pre-washing directly inside the tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisfied with the drying results, you can
A
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisfied with the drying results, you can
B
D
The current selection level number and rinse aid indicator light flash.
A
C
s.
The current selection level number and rinse aid indicator light flash.
s.
1. When measuring out the detergent refer to the mentioned
the dishwasher model. The factory setting is specific to the model,
earlier information to add the proper quantity. Inside the
B
dispenser
dosing.
2. Remove detergent residues from the edges of the dispenser
the dishwasher model. The factory setting is specific to the model,
and close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until
FILLING THE DETERGENT DISPENSER
the closing device is secured in place.
The detergent dispenser automatically opens up at the right time
The detergent dispenser automatically opens up at the right
dishwashers.
in the
according to the program. If all-in-one detergents are used, we
time according to the program. If all-in-one detergents are used,
recommend using the TABLET button, because it adjusts the
useof detergent, rinse aid liquid and refined salt is required.
FILLING THE DETERGENT DISPENSER
we recommend using the TABLET button, because it adjusts the
program so that the best washing and drying results are always
program so that the best washing and drying results are always
achieved.
achieved.
dishwashers.
useof detergent, rinse aid liquid and refined salt is required.
A
B
A
A
B
3sec
A
11
B
Display
7
8
Half Load indicator light
B
The detergent dispenser automatically opens up at the right time
9
Half Load button
according to the program. If all-in-one detergents are used, we
Delay button
10
recommend using the TABLET button, because it adjusts the
program so that the best washing and drying results are always
START/Pause button with indicator light / Tab
11
achieved.
The detergent dispenser automatically opens up at the right time
according to the program. If all-in-one detergents are used, we
recommend using the TABLET button, because it adjusts the
program so that the best washing and drying results are always
achieved.
10
11
7.
Display
To open the detergent dispenser
8.
Half Load indicator light
press button A.
9.
Half Load button
Introduce the detergent into
10. Delay button
the dry dispenser B only.
11. START/Pause button with indicator light / Tab
Place the amount of detergent
for pre-washing directly inside
the tub.
there are indications to help the detergent
D
To open the detergent dispenser
press button A.
Introduce the detergent into
the dry dispenser B only.
To open the detergent dispenser
Place the amount of detergent
for pre-washing directly inside
press button A.
the tub.
Introduce the detergent into
1
2
3
4
5
the dry dispenser B only.
50°
55°
65°
50°
65°
Place the amount of detergent
for pre-washing directly inside
the tub.
7
1. Remove the lower rack and
unscrew the reservoir cap
(anticlockwise).
2. Only the first time you do this: fill
the salt reservoir with water.
3. Position the funnel (see figure)
and fill the salt reservoir right up
to its edge (approximately 1 kg);
it is not unusual for a little water to
leak out.
4. Remove the funnel and wipe any
salt residue away from the
opening.
6
7
7 PROGRAMS
65°