Gap Power Speedrooter 92R Інструкція з експлуатації Посібник з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Очищувачі для труб Gap Power Speedrooter 92R. Gap Power Speedrooter 92R 10 сторінок. For 3” through 10” (75mm-250mm)

Друкувати сторінку

Cutter Application Chart (Table 2)

Cutter

Cat. #

Spear

SHD

Head

2UC

U-Cutter

3" Heavy

Duty Side

3HDSC

Cutter

Blades

3" Heavy

Duty Saw

3HDB

Blade

Large

Retrieving

RTR-2

Tool

Note: There are no fixed rules for what cutter to use. If one tool

doesn't take care of a stoppage, simply try another.

INSTALLING THE GUIDE TUBE HOLDER

To install the Guide Tube Holder on The Metro, follow the as-

sembly shown in the diagram below. Place the Guide Tube

Holder on the mounting knob, then thread it onto the bolt to se-

cure the Power Cable Feed. (See diagram below.)

To secure the end of the Guide Tube, place it between the frame

support tubes.

Typical Applications

Starting Drill—gets water

flowing.

For Cutting and Scraping

For Cutting & Scraping walls

of pipe.

For Cutting Roots

For removing loose objects or

broken cables.

Bend the Guide Tube back into the Holder so that it catches a

coil near the end of the Guide Tube. (See photo below.)

THE CABLE AND SPRING ARE UNDER TENSION

WHEN ATTACHED TO THE HOLDER.

USE CAUTION WHEN RELEASING THE GUIDE

OPERATION

SET-UP

MAKE SURE THE MOTOR SWITCH IS IN

Place machine at a distance not

greater than two feet (.6m) from the

drain opening. Be sure the Speed-

rooter Guide Tube (S92-GT) is in

place. If you can't get the machine

this close to the drain opening, run

the cable through the optional Guide

Tube Extension (GTE) or a metal

guide tube to prevent cable whip-

ping.

Position the air foot pedal for easy accessibility. The machine is

designed for one-person operation. Be sure you can quickly re-

move your foot from the pedal in an emergency.

Be sure the motor switch is in the off position.

Make sure the Power Cable Feed is set to match the cable size

you have selected. If you're using 3/4" or 5/8" cables, the feed

should be assembled with the raised side of the lower two caps

outward.

Select the proper cutting tool (See Cutter Application Chart—

Table 2). A good tool to start with is the Spearhead or 2" U-

Cutter. If you are having difficulty getting around a P-Trap or

close bend, try the flexible leader. After the line has been

opened, follow with larger blades, which scrape the inside edges

of the pipe, assuring a real cleaning job.

Insert the cutter into the female connector at the end of the cable

and tighten the connecting screw and lock washer firmly in

place.

Speedrooter 92R

TUBE FROM THE HOLDER.

THE 'OFF' POSITION!