GAPOSA QC400 Посібник - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник для Двигун GAPOSA QC400. GAPOSA QC400 16 сторінок. Automatic control unit for three/single-phase motors with digital or mechanical limits
Друкувати сторінку
DESCRIPTION
The QC400 has been designed to operate an industrial door safely under electrical control of a pushbutton or key switch.
Its intended use is to be connected to a suitable motor not exceeding the load for the controller.
Connections are provided for mains supply (both 3ph and 1ph), motor power, mechanical or electronic limits,
Push Buttons, Pneumatic or Electrical or Optical Safety Edge, Photo beam safety and 24VDC Auxiliary power (100mA
max). Optional plug-in connectors for Radio and Traffic light.
Basic functions include: - Stop, Open, Close, and Auto close via a time delay provided a suitable monitored safety edge is
fitted.
IMPORTANT SAFETY INSTRUCTIONS
These instructions contain important information on the installation and the use of the QC400 unit. Please keep them
even after installation. Do not start installing the QC400 unit without having first read these instructions. The installa-
tion can be made only by a qualified technician. In order to respect the rules in force, the installation must include an
automatic cut off switch with minimum distance between the contacts of at least 3mm. The safety of the control unit
depends on a correct installation. Be at a reasonable distance from shutter/awnings in movement. Check frequently if
any loss of balance, sign of wear or damages wires are shown. Do not use if any repairing or maintenance is needed.
GAPOSA declines all responsibility in case of improper use of the product or of an incorrect installation.
WARNING: it is very important for the people's safety to follow strictly these instructions.
IMPORTANT: Stay at distance while the shutter is in movement.
IMPORTANT: Frequently check whether any cable disconnects, wears out or any damage happens. Do not use the con-
trol unit in case a reparation or a maintenance job is required.
KEEP THIS INSTRUCTIONS.
Warning: it is highly recommended to activate the impulsive mode only after having completed the set-up and
adjustments of the control unit. In particular, during the mechanical limit switches adjustment, select always the dead-
man operation mode. During the encoder limit switches set-up the control unit will only allow the dead-man working
mode.
DIRECTIVES
2014/35/UE 2014/30/CE 2014/53/CE 2006/42/CE
EN 61000-6-2:2005 EN 61000-6-3:2007 + A1:2011
EN 60950-1:2006 + A1:2010 + A2:2013 +A11:2009 + A12:2011
EN 13241-1:2004 + A1:2011 EN 13849-1:2015
EN 12453:2017 EN 12978:2003 + A1:2009
EN 301489-1:2008 EN 301489-3:2002
EN 300220-2:2007 EN 13241-1:2004 + A1:2011
3