IKEA UDDARP Посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник для Посудомийна машина IKEA UDDARP. IKEA UDDARP 29 сторінок.
Також для IKEA UDDARP: Інструкція з монтажу Посібник з монтажу (25 сторінок), Посібник (28 сторінок)

IKEA UDDARP Посібник
ENGLISH

Daily use

1. Load laundry
Prepare the laundry, following the
recommendations given in the section "HINTS
AND TIPS". Open the door and load the laundry
into the drum, without exceeding the maximum
load capacities indicated in the Programme
Chart.
2. Close door
Pressing until the latch audibly locks,
and check that there is no laundry
trapped between the door glass and
the rubber seal.
3. Open water tap
Check that the washer dryer is connected
correctly to the water mains. Open the water tap.
Switching on the washer dryer machine
Press button
4. Selecting a programme and customising a cycle.
The following functions are possible with this appliance:
Wash only
Wash and dry
Dry only
Wash only
Select the required programme with the "Program selector" dial.
The washing machine automatically displays the default
temperature setting and then the duration of the washing cycle.
Adjust the temperature and/or spin speed settings if needed
with the relative buttons.
Press button "Temp°"
lower temperature settings until cold wash is set ("- -")
shown on display.
Press button "Spin speed"
lower spin speed settings until the spin cycle is turned off
("0" shown on display).
Pressing the button again sets the highest possible setting.
Select the required options (if necessary).
Press the button to select the option; the respective button
lamp illuminates.
Press the button again to cancel the option; the lamp
extinguishes.
If the selected option is not compatible with the
programme set, an error warning tone sounds and the indicator
lamp flashes three times. The option is not selected.
Wash and dry
To wash and dry a load with no interruption between the wash
and dry cycles, make sure that the load does not exceed the
maximum permissible drying load for the selected programme
(see the column "Max. load for drying cycle" in the Programme
chart).
1. Follow the instructions given in the paragraph "Wash
Only" to select and, if necessary, customise the required
programme.
2. Press "Drying settings" to select the required drying mode.
Two drying modes are available: automatic or timer.
Automatic drying with selectable levels:
In automatic drying mode, the washer dryer machine dries the
laundry until the set level of dryness is reached.
Pressing button "Drying settings" once automatically selects the
highest drying level available for the selected programme.
Press the button again to reduce the drying level.
The following levels are available:
Wardrobe
: laundry is completely dry and ready to be put
away in the wardrobe without ironing.
Hanger
: laundry is left slightly damp to minimise creasing.
Garments must be hung to air dry completely.
Iron
: garments are left reasonably damp to make ironing
easier.
; the lamp
flashes slowly.
to cycle through progressively
to cycle through progressively
To download the full version visit www.ikea.com
Timer drying mode:
Press button "Drying settings" repeatedly to set timer drying
mode. After cycling through all the automatic drying levels,
continue pressing button "Drying settings" until the desired time
is displayed. Values from 210 to 30 minutes are settable.
To wash a load of laundry larger than the maximum permissible
load for drying (see the column "Max. load for drying cycle"
in the Programme chart), remove a few garments once the
washing cycle has finished before starting the drying cycle.
Proceed as follows:
1. Follow the instructions given in the paragraph "Wash
Only" to select and, if necessary, customise the required
programme.
2. Do not include a drying cycle.
3. Once the washing cycle is finished, open the door and
remove a few garments to reduce the load. Now follow the
instructions for "Dry only".
N.B.: always allow a cooling down period after drying before
opening the door. When using the two preset cycles "Wash &
Dry 45'" and "Wash & Dry 90'", it is not necessary to select and
start a drying cycle.
Dry only
This function is used to simply dry a wet load washed previously
in the washer dryer or by hand.
1. Select a suitable programme for the laundry you want to dry
(e.g. select cotton to dry wet cotton laundry).
2. Press button "Dry only" to dry without a wash cycle.
3. Press "Drying settings" to select the required drying mode.
Two drying modes are available: automatic or timer.
Automatic drying with selectable levels:
In automatic drying mode, the washer dryer machine dries the
laundry until the set level of dryness is reached. Pressing button
"Drying settings" once automatically selects the highest drying
level available for the selected programme. Press the button
again to reduce the drying level.
The following levels are available:
Wardrobe
: laundry is completely dry and ready to be put
away in the wardrobe without ironing.
Hanger
: laundry is left slightly damp to minimise creasing.
Garments must be hung to air dry completely.
Iron
: garments are left reasonably damp to make ironing
easier.
Timer drying mode:
Press button "Drying settings" repeatedly to set timer drying
mode. After cycling through all the automatic drying levels,
continue pressing button "Drying settings" until the desired time
is displayed. Values from 210 to 30 minutes are settable.
N.B.: always allow a cooling down period after drying before
opening the door.
5. USING THE CORRECT AMOUNT OF DETERGENT
Pull out the tray and pour detergent into the relative
compartments as described in "Detergent dispenser".
This is only necessary when using a wash only or a wash + dry
programme.
6. Delaying the start of a programme
To set the selected programme to start at a later time (Max
24h), press the button to set the desired delay time.
The symbol
lights on the display when this fuction is
enabled. To cancel the delayed start, press the button again
untile the value ‚''0'' is shown on the display.

7. STARTING A PROGRAMME.

Press the START/PAUSE button.
The relative indicator lamp illuminates with a "beep", the door
locks and the door open
To change a programme while a cycle is in progress, press
START/PAUSE (confirmation "beep") to pause the washer dryer
(the START/ PAUSE lamp flashes amber slowly); then select the
required cycle and press START/PAUSE (confirmation "beep")
again. To open the door while a cycle is in progress, press
START/PAUSE; the door may be opened if the symbol
symbol extinguishes.
7
lights.