IKEA VALGJORD Посібник користувача - Сторінка 20

Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина IKEA VALGJORD. IKEA VALGJORD 28 сторінок.
Також для IKEA VALGJORD: Посібник (28 сторінок)

Друкувати сторінку

ENGLISH

Internal cleaning

• Carefully clean the appliance, including

the rubber gasket of the door, with a soft

moist cloth.

• If you regularly use short duration

programmes, these can leave deposits of

grease and limescale inside the

appliance. To prevent this, we

recommend to run long duration

programmes at least 2 times per month.

Troubleshooting

If the appliance does not start or it stops

during operation. Before you contact an

Authorised Service Centre, check if you can

solve the problem by yourself with the help

of the information in the table.

Problem and alarm code

You cannot activate the ap-

pliance.

The programme does not

start.

The appliance does not fill

with water.

The display shows

The appliance does not

drain the water.

The display shows

• Make sure that the mains plug is connected to the mains

socket.

• Make sure that there is no damaged fuse in the fuse box.

• Make sure that the appliance door is closed.

• If the delay start is set, cancel the setting or wait for the

end of the countdown.

• The appliance has started the procedure to recharge the

resin inside the water softener. The duration of the pro-

cedure is approximately 5 minutes.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clogged.

Clean the filter.

• Make sure that the inlet hose has no kinks or bends.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

We recommend to follow the

"sanitisation procedure" of the

appliance before and after a

long absence (e.g. holydays).

See "ExtraHygiene" in the

Options chapter .

With some problems, the display shows

an alarm code.

Possible solution