GAPOSA XQ50 Посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник для Віконні жалюзі GAPOSA XQ50. GAPOSA XQ50 16 сторінок. Tubular motors with mechanical limit switch and integrated receiver.
Також для GAPOSA XQ50: Інструкція з експлуатації (8 сторінок), Інструкція (4 сторінок), Короткий посібник з програмування (7 сторінок), Посібник (15 сторінок), Інструкція з експлуатації (13 сторінок), Посібник (13 сторінок), Інструкція з експлуатації (8 сторінок)

ELECTRICAL CONNECTION

IMPORTANT INFORMATION FOR ELECTRICIANS

• It is possible to connect in parallel electronic motors to a switch in

residential applications where the total power cable length does

not exceed 10 meters. The number of motors paralleled together

is limited to 4-5 according to the switch total amperage capacity.

• Electronic motors cannot be paralleled connected together

when controlled by a Building Management system (BMS).

• Compatibility between electronic motors and BMS must be

approved and tested by manufacturer of BMS.

• For standard motor operation only a standard switch allowing either

UP or DOWN but not both at the same time must be used. Only

mechanically or electrically interlocked switches can be used.

• Motors with electronic limits can be connected in parallel. The

maximum load of the switch must never be exceeded.

• When changing from UP to DOWN or vice versa, the switchover time

must at least be 0.5 seconds and effected through an OFF position.

Only switches with a defined neutral position or one with a built-in

switching delay should be used.

• An "active path" control unit which monitors the current draw is in

conflict with the motor and cannot be used.

2/2