Makita 0088381898102 Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 0088381898102. Makita 0088381898102 17 сторінок.

Друкувати сторінку

Makita 0088381898102 Інструкція з експлуатації

Switch action

► 1 . Switch trigger

CAUTION:

Before installing the battery car-

tridge into the tool, always check to see that the

switch trigger actuates properly and returns to

the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool

speed is increased by increasing pressure on the switch

trigger. Release the switch trigger to stop.

NOTE: The tool automatically stops when you keep

pulling the switch trigger for 6 minutes.

NOTE: When full speed mode is turned on, the rota-

tion speed becomes fastest even if you do not pull the

switch trigger fully.

For detail information, refer to the section of full speed

mode.

Lighting up the front lamp

CAUTION:

Do not look in the light or see the

source of light directly.

► 1 . Lamp

► 1 . Button

To turn on the lamp status, press the button

turn off the lamp status, press the button

With the lamp status ON, pull the switch trigger to turn on

the lamp. To turn off, release it. The lamp goes out approx-

imately 10 seconds after releasing the switch trigger.

With the lamp status OFF, the lamp does not turn on

even if pulling the trigger.

NOTE: To confirm the lamp status, pull the trigger. When the

lamp lights up by pulling the switch trigger, the lamp status is

ON. When the lamp does not come on, the lamp status is OFF.

NOTE: When the tool is overheated, the light flashes

for one minute, and then the LED display goes off. In

this case, cool down the tool before operating again.

NOTE: Use a dry cloth to wipe the dirt off the lens of

the lamp. Be careful not to scratch the lens of lamp, or

it may lower the illumination.

NOTE: While pulling the switch trigger, the lamp

status cannot be changed.

NOTE: For approximately 10 seconds after releasing

the switch trigger, the lamp status can be changed.

Reversing switch action

► 1 . Reversing switch lever

CAUTION:

Always check the direction of

rotation before operation.

CAUTION:

Use the reversing switch only after

the tool comes to a complete stop. Changing the direc-

tion of rotation before the tool stops may damage the tool.

CAUTION:

When not operating the tool, always

set the reversing switch lever to the neutral position.

7 ENGLISH

for one second. To

for one second again.