Makita 1911B Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 1911B. Makita 1911B 18 сторінок. Power planer
Також для Makita 1911B: Інструкція з експлуатації (12 сторінок), Інструкція з експлуатації (16 сторінок), Інструкція з експлуатації (13 сторінок), Інструкція з експлуатації (12 сторінок)

Друкувати сторінку

OPERATING INSTRUCTIONS

Removing or installing planer blades

(Fig. 1, 3 & 4)

Important:

• Always be sure that machine is switched off and

unplugged before removing or installing the blade.

• Use the following planer blades.

Part Nos. 793008-8 793009-6 A-07412

*P-04232

Blades with * mark are available in European coun-

tries only. Consult your dealer or the Makita Service

Center when purchasing blades.

To remove the blades on the drum, unscrew the

installation bolts with the socket wrench. The drum

cover comes off together with the blades.

To install the blades, first clean out all chips or foreign

matter adhering to the drum or blades. Use blades of

the

same

dimensions

oscillation/vibration will result, causing poor planing

action and, eventually, machine breakdown.

For the correct planer blade setting

Your planing surface will end up rough and uneven, unless the blade is set properly and securely. The blade

must be mounted so that the cutting edge is absolutely level, that is, parallel to the surface of the rear base.

Below are some examples of proper and improper settings.

(A) Front base (Movable shoe)

(B) Rear base (Stationary shoe)

Correct setting

Nicks in surface

Gouging at start

Gouging at end

and

weight,

drum

Place the blade on the gauge base so that the blade

edge is perfectly flush with the inside edge of the

gauge plate. Place the adjust plate on the blade, then

simply press in the heel of the adjust plate flush with

the back side of the gauge base and tighten two

screws on the adjust plate. Now slip the heel of the

adjust plate into the drum groove, then fit the drum

cover on it. Tighten the installation bolts evenly and

alternately with the socket wrench.

CAUTION:

Tighten the blade installation bolts carefully when

attaching the blades to the machine. A loose installa-

tion bolt can be dangerous. Always check to see they

are tightened securely.

Although this side view cannot show

it, the edges of the blades run

perfectly parallel to the rear base sur-

face.

Cause: One or both blades fails to

Cause: One or both blade edges fails

Cause: One or both blade edges

have edge parallel to rear

base line.

to protrude enough in relation

to rear base line.

protrudes too far in relation to

rear base line.