Makita 3601B Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 3601B. Makita 3601B 13 сторінок. Router
Також для Makita 3601B: Інструкція з експлуатації (13 сторінок), Інструкція з експлуатації (20 сторінок)

Друкувати сторінку

Straight guide

005043

The straight guide is effectively used for straight cuts

when chamfering or grooving.

To install the straight guide, insert the guide bar into the

holes in the tool base until the notch in the guide bar

reaches just under the wing bolt (B). Then tighten wing

bolt (B). Loosen the wing bolt (A) and adjust the distance

between the bit and the straight guide. At the desired

distance, tighten the wing bolt (A) to secure the straight

guide in place.

005044

When cutting, move the tool with the straight guide flush

with the side of the workpiece.

Templet guide (Accessory)

005045

The templet guide provides a sleeve through which the

bit passes, allowing use of the tool with templet patterns.

To install the templet guide, screw the templet guide on

the base plate.

1. Wing bolt (B)

2. Wing bolt (A)

3. Straight guide

4. Guide bar

005046

Secure the templet to the workpiece. Place the tool on

the templet and move the tool with the templet guide

sliding along the side of the templet.

003695

NOTE:

The workpiece will be cut a slightly different size

•

from the templet. Allow for the distance (X)

between the bit and the outside of the templet

guide. The distance (X) can be calculated by using

the following equation:

Distance (X) = (outside diameter of the templet

guide - bit diameter) / 2

Trimmer guide (Accessory)

005047

Trimming, curved cuts in veneers for furniture and the

like can be done easily with the trimmer guide. The

guide roller rides the curve and assures a fine cut.

Install the trimmer guide on the tool base with the wing

bolts (B). Loosen the wing bolt (A) and adjust the

distance between the bit and the trimmer guide by

turning the fine adjusting screw (1.5 mm per turn). At the

desired distance, tighten the wing bolt (A) to secure the

trimmer guide in place. When adjusting the guide roller

up or down, loosen the wing bolt (C). After adjusting it,

1. Base plate

2. Templet guide

1. Bit

2. Base

3. Templet

4. Workpiece

5. Distance (X)

6. Outside

diameter of the

templet guide

7. Templet guide