CORNING 6780-NP Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Лабораторне обладнання CORNING 6780-NP. CORNING 6780-NP 10 сторінок. Digital microplate and orbital shakers
Також для CORNING 6780-NP: Інструкція з експлуатації (13 сторінок)
Друкувати сторінку
5.3 Additional Operations
Power
If you want to view the set value for RPM during shaking, rotate the encoder knob for ONE CLICK right (+) or left (-). The RPM signal
light will flash for 2 seconds, and the display will show the set RPM. After 2 seconds the RPM and the signal light will stop flashing.
NOTE: The shaker must be in RPM mode – RPM signal light must be on.
Power
If you want to view the set value for TIME during shaking, rotate the encoder knob ONE CLICK right (+) or left (-). The TIME signal
light will flash for 2 seconds, and the display will show the set TIME. After 2 seconds the display will return to the count TIME, and
the signal light will stop flashing.
NOTE: The shaker must be in the TIME mode – the TIME signal light must be on.
6.0 Troubleshooting
Problem
POWER key does not light
Shaker stalls – Message Er1
Display does not light
Message Er2 on display
Message Er3 on display
Message Er4 on display
Should you have a question about the operation of the Corning® LSE™ Digital Microplate and Orbital Shakers or if service is required,
please contact Corning Customer Service at 800.492.1110 or 978.442.2200.
6
|
CORNING LSE DIGITAL MICROPLATE AND ORBITAL SHAKERS
Run
Time
Speed
ENCODER
Speed(RPM) Time(min)
PUSH
(Time/Speed)
Run
Time
Speed
ENCODER
Speed(RPM) Time(min)
PUSH
(Time/Speed)
Solution
Check the power source.
Check fuses.
Power the unit down, then restart.
Contact Corning Customer Service.
Start
Stop
Start
Stop