Makita 3700B Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 3700B. Makita 3700B 12 сторінок. Laminate trimmer
Також для Makita 3700B: Розбивка на частини (2 сторінок)
Друкувати сторінку
10mm
(3/8")
1
2
007113
Loosen the screws and remove the base protector.
Place the templet guide on the base and replace the
base protector. Then secure the base protector by
tightening the screws.
1
2
3
4
005435
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the router bit and the outside of the
templet guide. The distance (X) can be calculated
by using the following equation:
Distance (X) = (outside diameter of the templet guide -
router bit diameter) / 2
Straight guide (optional accessory)
007109
The straight guide is effectively used for straight cuts
when chamfering or grooving.
1. Base protector
2. Screw
3. Base
3
1. Bit
5
2. Base
3. Templet
4. Workpiece
5. Templet guide
1
2
3
4
5
6
013239
Attach the guide plate to the straight guide with the bolt,
the flat washer, the wave washer and the wing nut.
Remove the guide holder and the chip deflector.
1
2
3
013237
Attach the straight guide with the clamp screw (A).
Loosen the wing nut on the straight guide and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing nut securely.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
A
013212
If the distance (A) between the side of the workpiece
and the cutting position is too wide for the straight guide,
or if the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a
straight board to the workpiece and use it as a guide
against the trimmer base. Feed the tool in the direction
of the arrow.
Circular work
Circular work may be accomplished if you assemble the
straight guide and guide plate.
Min. and max. radius of circles to be cut (distance
between the center of circle and the center of bit) are as
follows:
Min.: 70 mm
Max.: 221 mm
6
1. Bolt
2. Guide plate
3. Straight guide
4. Flat washer
5. Wave washer
6. Wing nut
1. Clamp screw (A)
2. Straight guide
3. Guide plate
4. Wing nut
4