Makita 3707FC Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 3707FC. Makita 3707FC 16 сторінок. Trimmer
Також для Makita 3707FC: Технічні характеристики (2 сторінок), Розбивка на частини (3 сторінок), Інструкція з експлуатації (10 сторінок), Інструкція з експлуатації (13 сторінок)
![Makita 3707FC Інструкція з експлуатації](/uploads/products/server2/2090106/2090106.png)
ASSEMBLY
2
1
3
1. Loosen
2. Tighten
3. Hold
OPERATION
2
1
1. Feed direction
2. Bit revolving direction
3. Workpiece
4. Straight guide
6
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing trimmer bit
001700
CAUTION:
•
Do not tighten the collet nut without inserting a bit, or the collet cone will
break.
•
Use only the wrenches provided with the tool.
Insert the bit all the way into the collet cone and tighten the collet nut securely
with the two wrenches.
To remove the bit, follow the installation procedure in reverse.
Set the tool base on the workpiece to be cut without the bit making any con-
tact. Then turn the tool on and wait until the bit attains full speed. Move the tool
forward over the workpiece surface, keeping the tool base flush and advanc-
ing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should be on the left side of
the bit in the feed direction.
1
1. Workpiece
3. View from the top of the tool
001985
NOTE:
3
•
Moving the tool forward too fast may cause a poor quality of cut, or
damage to the bit or motor. Moving the tool forward too slowly may burn
and mar the cut. The proper feed rate will depend on the bit size, the kind
of workpiece and depth of cut. Before beginning the cut on the actual
workpiece, it is advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look as well as enable you
4
to check dimensions.
•
When using the trimmer shoe, the straight guide or the trimmer guide, be
sure to keep it on the right side in the feed direction. This will help to
keep it flush with the side of the workpiece.
CAUTION:
•
Since excessive cutting may cause overload of the motor or difficulty in
controlling the tool, the depth of cut should not be more than 3 mm at a
pass when cutting grooves. When you wish to cut grooves more than
3 mm deep, make several passes with progressively deeper bit settings.
4
2
3
001984
2
4
2. Bit revolving direction
4. Feed direction