Makita 3708FC Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 3708FC. Makita 3708FC 16 сторінок. Trimmer
Також для Makita 3708FC: Технічні характеристики (2 сторінок), Перелік деталей (3 сторінок), Розбивка на частини (3 сторінок), Інструкція з експлуатації (12 сторінок)
Друкувати сторінку
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing trimmer bit
2
1
3
002003
CAUTION:
Do not tighten the collet nut without inserting a bit,
•
or the collet cone will break.
Use only the wrenches provided with the tool.
•
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches.
To remove the bit, follow the installation procedure in
reverse.
Installing trimmer shoe (after it has been
removed from the tool)
1
2
1. Bolt
2. Flat washer (large)
3. Trimmer shoe
4. Flat washer (small)
5. Spring washer
6. Wing nut
7. Base
002004
NOTE:
The trimmer shoe is factory installed on the tool.
•
Use the bolts, wing nuts, spring washers and flat
washers to install the trimmer shoe as shown in the
figure.
1. Loosen
2. Tighten
3. Hold
5
3
4
7
OPERATION
1
002005
Turn the tool on without the bit making any contact with
the workpiece and wait until the bit attains full speed.
Then move the tool over the workpiece surface, keeping
the tool base and trimmer shoe flush with the sides of the
workpiece.
NOTE:
This tool can be used as a conventional trimmer
•
when you remove the trimmer shoe.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
1
2
6
1. Workpiece
2. Bit revolving direction
3. View from the top of the tool
4. Feed direction
001984
NOTE:
Moving the tool forward too fast may cause a poor
•
quality of cut, or damage to the bit or motor. Moving
the tool forward too slowly may burn and mar the
cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is
advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
When using the trimmer shoe, the straight guide or
•
the trimmer guide, be sure to keep it on the right
side in the feed direction. This will help to keep it
flush with the side of the workpiece.
6
1. Trimmer shoe
2. Base
2
4
4
3
2