Makita 3901 Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 3901. Makita 3901 17 сторінок. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
Також для Makita 3901: Брошура (1 сторінок), Інструкція з експлуатації (16 сторінок), Інструкція з експлуатації (12 сторінок)

Друкувати сторінку

FUNCTIONAL

DESCRIPTION

1. Pointer

2. Stopper

3. Adjusting screw

1. Lock lever

2. Angle guide

3. Knob

4. Scale

5. Pointer

1. Knob

2. Down

3. Up

4. Center of blade thickness

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

adjusting or checking function on the tool.

Adjusting the depth of cut

004574

6 cutting depths can be preset according to the size of biscuit to be used or if

trimming the wall or ceiling panels as explained later. Rotate the stopper until

the pointer points to the appropriate size marked on the stopper.

Refer to the table below for the correspondence between the sizes marked on

the stopper and the biscuit size. Fine adjustments to the cutting depth can be

made by turning the adjusting screw after loosening the hex nut. This may

become necessary after the blade has been resharpened a few times.

Size on stopper

Biscuit size

Depth of cut

Angle guide

004575

The angle guide can be moved up and down to adjust the position of the blade

in relation to the top of the workpiece.

To adjust the angle guide height, loosen the lock lever down and rotate the

knob until the pointer points to the desired scale graduation marked on the

angle guide. Then tighten the lock lever up to secure the angle guide.

The scale on the angle guide indicates the distance from the top of the work-

piece to the center of the blade thickness.

004576

8 mm

10 mm 12.3 mm 13 mm 14.7 mm 20 mm

C00084

MAX