ALIBI ALI-NS2036VR Посібник зі швидкого встановлення - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Камера спостереження ALIBI ALI-NS2036VR. ALIBI ALI-NS2036VR 6 сторінок. 6mp vandalproof ip dome camera
Друкувати сторінку
Selected
Activate
Click the Activate button. In the Activate window, you will create a password for the admin
2.
(administrator) username.
a.
In the Activate window, enter an a password for admin in the New Password field.
Include a combination of uppercase, lowercase alphabetic characters and numbers to
create a "Strong" password. The rating is shown beneath the Password field. See above.
b.
Enter the admin password again in the Confirm field, and then click Activate. In the
screen below, notice that the device Security status shows "Active". Record your admin
password for reference later.
If you lose your admin (administrator) password, you cannot configure the device or restore
it to its factory settings. To reset your password, call your support organization for specific
CAUTION
instructions.
Notice that although the device is now activated, it retained the default IP address.
Step 4.
Edit Network Parameters
NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip
this step. The camera will receive network configuration settings from the NVR. Refer to the
documentation available for your NVR firmware for more information.
You can change the network parameters of devices that are active.
1.
In the list of devices discovered, click on the device you want to change the network settings
for, and then click the select box to check it. See below.
Edit Network Parameters
2.
In the popup window, edit the current network parameters, and then enter the Administrator
(admin) user password in the field at the bottom.
Enable DHCP: You can select Enable DHCP to acquire compatible network settings
a.
from a DHCP server installed on the LAN. However, these settings might be changed
later by the DHCP server. Since it is recommended to use an unchanging IP address, you
can use DHCP to acquire compatible network settings, and then uncheck Enable DHCP
and save that configuration to retain the new network parameters.
In the example below, Enable DHCP was checked to acquire compatible network
b.
settings from the DHCP server.
3
www.observint.com
Click OK to save your settings. The parameter change(s) will be shown device's network parameters
3.
(see below).
Step 5.
Login to the camera
NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip this step.
Microsoft® IE is used to access your camera remotely. IE must run as an Administrator to use all features
available through a remote login to the camera.
Setting MS Internet Explorer to run as an Administrator
Window 7: To run IE as an Administrator:
1.
Find or create an IE icon on your computer desktop.
2.
Hold down the shift key, and then right-click on the IE icon.
MS Internet
Explorer icon
3.
Click Run as administrator in the pop-up menu.
Window 10: To run IE as an Administrator:
Find MS IE in the start menu. Usually this is found in the Windows Accessories group.
1.
2.
Pin the entry to Start.
3.
Right click on the Internet Explorer tile, and then select More | Run as administrator.
Run as administrator
Run as
administrator
© 2019 Observint Technologies. All rights reserved.