Makita 4131 Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 4131. Makita 4131 12 сторінок. Metal cutter
Також для Makita 4131: Інструкція з експлуатації (14 сторінок), Інструкція з експлуатації (12 сторінок), Інструкція з експлуатації (12 сторінок), Інструкція з експлуатації (12 сторінок)
Друкувати сторінку
SPECIFICATIONS
Max. cutting capacity
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
SYMBOLS
The following show the symbols used for the tool. Be
sure that you understand their meaning before use.
...................Read instruction manual.
...................DOUBLE INSULATION
..................Pay attention! It may become too hot.
..................Only for EU countries
Do not dispose of electric equipment
together with household waste mate-
rial!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its imple-
mentation in accordance with
national law, electric equipment that
have reached the end of their life
must be collected separately and
returned to an environmentally com-
patible recycling facility.
Intended use
The tool is intended for cutting in mild steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
2
Model
Balde diameter
-1
)
Overall length
Net weight
Safety class
END209-2
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 99 dB (A)
sound power level: 110 dB (A)
Uncertainty: 3 dB(A)
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in compliance with the following standards of stand-
ardized documents, EN60745, EN55014, EN61000 in
accordance with Council Directives, 73/23/EEC, 89/336/
EEC, 98/37/EC.
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
4131
185 mm
63 mm
3,500
358 mm
4.8 kg
/II
2
.
Yasuhiko Kanzaki CE 2004
Director