CORNING PC-600D Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Лабораторне обладнання CORNING PC-600D. CORNING PC-600D 11 сторінок. Digital hot plates, stirring hot plates, stirrers, and external temperature controller
Також для CORNING PC-600D: Інструкція з експлуатації (8 сторінок), Інструкція з експлуатації (14 сторінок), Інструкція з експлуатації (14 сторінок)
Друкувати сторінку
Product Controls and Indicators
1
2
1 Power Indicator: Illuminates at all times when the product is properly
connected to input power.
2 Stir Control Knob: Turn it all the way counterclockwise to turn off
stirring function. Turn it clockwise to set desired stirring speed.
3 Stirring Speed Display: Shows the speed set for stirring
4 Heat Control Knob: Turn it all the way counterclockwise to turn off
heating function. Turn it clockwise to set desired heating temperature.
5 Heating Temperature Display: Shows the temperature set for heating.
6 Hot Top Indicator: Illuminates when the temperature of the top is too
hot to touch (greater than ~60°C).
7 Temperature Probe In Use Indicator: Illuminates when the external
temperature probe is connected to the unit.
Product Connections
1 Power Cord Input: Connect the supplied power cord into this
connector.
2 External Temperature Controller Input: Connect the optional External
Temperature Controller (Corning Cat. No. 6795PR) into this connector.
2
4
7
6
3
5
4
1
To Connect the External Temperature Controller
1 Turn the Stir Control Knob and Heat Control Knob to the OFF
position.
2 Disconnect power cord.
3 Insert temperature controller connector into the input connector.
4 Reconnect power cord.
5 Product is now ready for use with External Temperature Controller.
Repeat the above process when disconnecting the temperature controller.
Stirring Instructions
PC-410D, PC-420D, PC-610D, PC-620D
1 Fill vessel with solution to be stirred.
2 Place stir bar into vessel.
3 Place vessel in the center of the top surface.
4 Turn Stir Control Knob until the Stirring Speed Display shows the
desired speed. The speed setting can be adjusted according to the
table below.
Operating Range (RPM)
60-100
100-200
200-400
400-1150
- Flashing Display: The number will FLASH when actual stirring
speed is not at set speed.
- Constant Display: The number will not flash when actual stirring
speed is at the set speed. The number will remain constantly ON
when the actual stirring speed is at the set speed.
5 When desired stirring is complete, turn the Stir Control Knob to the
OFF position. Allow stir bar to cease rotation before removing the
vessel from the unit.
6 Heating and stirring can be performed simultaneously with PC-420D
and PC-620D models which offer both heating and stirring functions.
Please note that the viscosity of the stirred material will affect the ability
of the stir bar to remain coupled to the rotating ring magnet. Materials
of high viscosity must be stirred at slower speed settings.
Adjustable Increment, (RPM)
5
10
20
50
5