GarageAce S3 Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Відкривач гаражних дверей GarageAce S3. GarageAce S3 16 сторінок.
Друкувати сторінку4.4. Advanced setting
In the ready status, press the "P" button until LED shows the picture shows as Fig25, then
release the button.
4.4.1. Transmitter setting
When the LED turns on as Fig 25. Press "+" or "-" to set between 0 and 2. "0"
stands for two button control; "1" stands for single button control(the one learned);
"2" stands for first button controls the door and second button controls the light.
Press "P" to confirm the setting. If there is no need to change the setting, you can
just press "P" to enter into the next setting.
4.4.2. Auto closing setting
When the LED turns on as Fig 26. Press "+" and "-" to set between 0 and 1. "0"
stands for auto closing has no relationship with photo beam; "1" stands for
forbidden to use auto closing when photo beam is set as 0. Press "P" to confirm
the setting. If there is no need to change the setting, you can just press "P" to enter
into the next setting.
4.4.3. Reset to factory setting
When LED turns on as Fig 27. Press "+" and "-" to set between 0 and 2. "0"
stands no Reset to factory setting; "1" stands for Reset to factory setting and keep
the transmitters; "2" stands for Reset to factory setting and delete the transmitters.
Press "P" to confirm your setting and get out of the setting situation automatically.
4.5. Fault information
This opener can auto detect any errors during running, and will display the error information.
When an error occurs, LED screen will display the error code, the dot will also flash quickly.
After 5 seconds of flashing the error information, it will automatically recover to display
normally.
a) "1.": means the limit setting is at fault.
b) "2.": means the door has hit an obstruction while opening
c) "3.": means the door has hit an obstruction while closing.
d) "4.": means the photo beam is shielded or photocell is damaged.
e) "5.": means the transmitter has an error in learning or coding.
f) "6.": means the running time exceeds 100 seconds.
g) "7.": means the speed sensor is damaged.
h) "8.": means the DC motor is damaged.
5.
Locking the door manually
As shown in Fig. 28, if the door is open when the power is
off, you can disconnect the clutch, pull the door to the close
position by hand, the door can be locked in the limitation hole of rail.
When the power is on, it is not necessary to open lock by hand,
only operate remoter or push button directly. When the opener runs to the close position, the
clutch will be connect automatically and unlock simultaneously, then the door can be
opened and closed by electricity normally.
Notice: Please be gentle with clutch in case of damaging
8
Figure 25
Figure 26
Figure 27
Figure 28