CORNING ONE GX Загальний інформаційний посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Загальний інформаційний посібник для Вимірювальні прилади CORNING ONE GX. CORNING ONE GX 12 сторінок. Higher power 40 w dual-band wcs/2.5 ghz tdd das remote
Також для CORNING ONE GX: Інструкція по швидкому встановленню (14 сторінок)

Друкувати сторінку

MOUNT THE GX ONTO THE BRACKET

Step 1.

Referring to Figure 7, carefully fit and hang the

GX unit onto the bracket with the connectors

facing down.

Step 2.

Referring to Figure 8, secure the GX unit to the

bracket by inserting the two provided M8 bolts

into the frame of the GX underside panel.

Step 3.

Using a spanner or wrench, tighten the two

M8 nuts.

Note:

Using a thread locker is recommended to

tightly seal the nuts.

Step 4.

Verify that unit is mounted securely to the bracket.

FOR DEPLOYMENTS ALONGSIDE GX QUAD-

BAND UNITS – INSTALL GX 2x1 EXTERNAL

LOW-BAND AND HIGH-BAND COMBINER

Notes:

GX dual-band can be deployed alongside the

following GX quad-band units:

• GX-E17E85P19L70-40

• GX-E17E85P19L70-40-DC

Refer to GX low-band and high-band external

combiner (AK-GX-LH-COMB) quick installation

sheet for detailed installation procedure

instructions.

The GX low-band and high-band external

combiner interfaces to the GX dual-band and

to the GX 4x1 external combiner (AK-GX-ECPL-

COMB) converging the frequencies received from

the GX quad-band

The GX 2x1 external combiner should be

mounted adjacent to the GX dual-band RF

interfaces (DIN to DIN cables = 1.2 m).

For wall-mountable installations:

Step 1.

Using combiner bracket mounting holes

(indicated as "A" in Figure 9) as a guide, mark

and drill four holes for M6 bolts (provided with

external combiner).

Step 2.

Mount combiner on wall using the provided M6

bolts and spring and flat washers (four of each).

For pole-mountable installations:

Slip a hose clamp through the holes (indicated as "B" Figure 9)

at each end of the factory-assembled mounting bracket and

secure to pole by tightening.

Corning Optical Communications

Figure 7. Hanging GX on Bracket

Figure 8. Tightening M8 Nuts – Underside

Figure 9. External Combiner Mounting Options and

Grounding Lug

Quick Installation Sheet | CMA-600-AEN | Page 7