Jamba Juice Smoothie & Ice Pop Maker Брошура з інструкціями та рецептами - Сторінка 7
Переглянути онлайн або завантажити pdf Брошура з інструкціями та рецептами для Кухонна техніка Jamba Juice Smoothie & Ice Pop Maker. Jamba Juice Smoothie & Ice Pop Maker 12 сторінок. Ez-2make
Symptom
My Drink recipe has not mixed very
well.
The Smoothie Maker will not
switch on.
The Smoothie Maker has stopped
mixing.
The ice pops are difficult to remove
from the molds.
The ice pops sticks come away from
the pops and the ice pop is stuck in
the molds.
Problem
You have not mixed the contents for
a long enough period.
The batteries are dead. OR
The batteries are not connected
properly. OR
The jug and motorized unit are not
properly connected together. OR
The lid is not slid into place.
May be jammed.
OR
Isolation switch has been
activated. OR
The lid may be partially open.
The ice pops are frozen hard & stuck
in the mold.
The ice pops have not completely
frozen. OR
The mix has not frozen well to the
ice pop stick.
Solution
Pour the contents back into the smoothie mixing jug and mix
again.
Replace the 4 x C batteries.
Open the battery compartment and check that the batteries are
connected using the correct polarities (+/-).
Ensure that the hinges are sitting in the cradle correctly and
the jug is clicked into the base correctly.
Slide the lid along its track, into closed position.
Use only soft, ripe ingredients. Switch the Smoothie Maker
off first, before removing jammed food items.
Ensure that the hinges are sitting in the cradle correctly and
the jug is clicked into the base correctly.
Slide the lid along its track, into closed position.
Leave to stand for a few minutes or ask an adult to run warm
water over the sides of the mold for a few moments.
NOTE: NEVER USE HOT OR BOILED WATER!
Place back in the freezer for a few more hours.
Take the sticks out and pour a small amount of cold water into
the slit made by the ice pop sticks. Replace the ice pop sticks &
place back in the freezer for a few more hours. When removing,
ask an adult to run warm water over the sides of the ice pop
mold for a few moments. NOTE: NEVER USE HOT OR BOILED
WATER! Also, try to make the mix a chunkier consistency.
7