Makita 5477NB Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 5477NB. Makita 5477NB 12 сторінок. Hypoid saw 185mm (7-1/4")
Також для Makita 5477NB: Технічна інформація (8 сторінок)

Друкувати сторінку

CAUTION:

One side of the inner flange is for 5/8" hole

•

diameter of the blade and the other side is for

13/16" hole diameter. Use the correct side for the

hole diameter of the blade you intend to use.

Mounting the blade on the wrong side can result in

dangerous vibration.

007400

OPERATION

CAUTION:

Be sure to move the tool forward in a straight line

•

gently. Forcing or twisting the tool will result in

overheating the motor and dangerous kickback,

possibly causing severe injury.

009232

Hold the tool firmly. The tool is provided with both a front

grip and rear handle. Use both to best grasp the tool. If

both hands are holding saw, they cannot be cut by the

blade. Set the base on the workpiece to be cut without

the blade making any contact. Then turn the tool on and

wait until the blade attains full speed. Now simply move

the tool forward over the workpiece surface, keeping it

flat and advancing smoothly until the sawing is

completed.

To get clean cuts, keep your sawing line straight and your

speed of advance uniform. If the cut fails to properly

follow your intended cut line, do not attempt to turn or

force the tool back to the cut line. Doing so may bind the

blade and lead to dangerous kickback and possible

serious injury. Release switch, wait for blade to stop and

then withdraw tool. Realign tool on new cut line, and start

cut again. Attempt to avoid positioning which exposes

operator to chips and wood dust being ejected from saw.

Use eye protection to help avoid injury.

1. Ring 17

2. Inner flange

3. Blade

4. Outer flange

5. Hex bolt

6. Mounting shaft

1. Front handle

2. Rear handle

3. Base

Rip fence (Guide rule) - optional accessory

009233

The handy rip fence allows you to do extra-accurate

straight cuts. Simply slide the rip fence up snugly against

the side of the workpiece and secure it in position with

the screw on the front of the base. It also makes repeated

cuts of uniform width possible.

Hook (Optional accessory)

009328

CAUTION:

Always unplug the tool when hanging the tool using

•

the hook.

Never hook the tool at high location or on

•

potentially unstable surface.

The hook is convenient for hanging the tool temporarily.

To use the hook, simply lift up hook until it snaps into the

open position.

When not in use, always lower hook until it snaps into the

closed position.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or the

•

like. Discoloration, deformation or cracks may

result.

Adjusting for accuracy of 90° and 45° cut

(vertical and 45° cut)

This adjustment has been made at the factory. But if it is

off, adjust the adjusting screws with a hex wrench while

inspecting 90° or 45° the blade with the base using a

triangular rule or square rule, etc.

1. Rip fence (Guide

rule)

1. Hook