CORNING EDGE8 Series Посібник - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник для Стелажі та підставки CORNING EDGE8 Series. CORNING EDGE8 Series 11 сторінок. Single-module housing
Також для CORNING EDGE8 Series: Встановлення (4 сторінок)

Друкувати сторінку

MOUNTING THE CABINET

4.1. To a Wall

Step 1:

Install (4) supplied wall-mounting brackets to cabinet using provided screws (Figure 1).

Step 2:

Determine the mounting location. Select a flat vertical surface for mounting to prevent

warping.

IMPORTANT: Make sure there is adequate space for the door to open without interference.

Step 3:

Use a pencil to mark the wall through the holes in the mounting brackets.

Step 4:

Drive the screws in at these locations.

Step 5:

Hang the cabinet on the screws and tighten screws securely.

4.2. Underneath a Raised Floor

4.2.1 Direct Method

IMPORTANT: Due to variations in raised floor

systems, installation sequences may

deviate from this direct installation

method. If necessary, proceed to Section

4.2.2 or 4.2.3 for alternative installation

methods.

Step 1:

Select an installation location

and remove five adjacent floor

tiles in a "+" pattern using a

panel-lift tool. The unit will be installed in the center of the "+."

NOTE:

Although the FZB can be installed by removing only two floor tiles or panels (when it is not practical

to remove more), removing five panels facilitates installation and inspection for obstacles.

Step 2:

Install provided floor trim plates (p/n 10-

031423-001) on both sides of the housing

with provided screws.

Step 3:

Lower housing into center opening of floor

tiles. Opening the door and using the interior

ledge of the housing as a handle may

facilitate installation. The trim plates should

rest directly on the floor system posts or

"stanchions."

STANDARD RECOMMENDED PROCEDURE 003-825-AEN | ISSUE 7 | NOVEMBER 2020 | PAGE 3 OF 11

Figure 4

Figure 5