Avantgarde TBWC-30SFD Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Охолоджувач для вина Avantgarde TBWC-30SFD. Avantgarde TBWC-30SFD 10 сторінок. Built-in wine cooler
Також для Avantgarde TBWC-30SFD: Інструкція з експлуатації (19 сторінок)
Друкувати сторінку3. INSTALLATION INSTRUCTIONS
BEFORE
U SING
Y OUR
A PPLIANCE
Remove the exterior and interior packing.
•
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will
•
reduce the possibility of a malfunction in the cooling system from improper handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
•
INSTALLATION
S PECIFICATIONS
This appliance requires a standard 115 Volt A.C. /50Hz electrical outlet with three-prong ground
•
This appliance is designed to be installed built-in or free standing.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
•
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Ambient
temperature below 68°F (20°C) or above 90°F (32°C) will hinder the performance of this appliance. This
unit is not designed for use in a garage or any other outside installation.
Avoid locating the appliance in moist areas.
•
Plug the appliance into dedicated, properly installed-grounded wall outlet. Do not under any circumstances
•
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center. This unit is not
designed to be installed in an RV or used with an inverter.
After
p lugging
t he
a ppliance
i nto
a
w all
o utlet,
a llow
t he
u nit
t o
c ool
d own
f or
3
~
•
4
h ours
b efore
p lacing
w ine
b ottles
o r
b everage
c ans
i n
t he
a ppliance.
This
w ine
c ooler
c ome
w ith
a djustable
l egs
( in
t he
f ront)
t o
h elp
l evel
t he
u nit
•
BUILT-‐IN
I NSTALLATION
The cutout dimension illustrated in figure (A) allows for door swing and access to the pull-out shelves when
installed as a built-in appliance. If installing between frameless cabinets, a ½" wide filler strip or side panel may
be needed on hinge side. The filler strip will act as a spacer between the appliance case and adjacent cabinet
door swing. The width of the opening must include the filter panels.
Note:
The door should protrude at least 1" beyond the surrounding cabinets.
23"Including
d oor
24
½ "
( Including
h andle)
21
¼ "
( cabinet)
33
3 /4"
15"
15-3/4"
min
14