Makita 903DW Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 903DW. Makita 903DW 17 сторінок. Cordless blade sharpener
Друкувати сторінку
Installing or removing wheel point
CAUTION :
Always be sure that
the
tool
is
switched off and
the
battery cartridge
is
removed before
installing or removing the wheel point.
Remove the guide from the tool when it is
installed on the tool. Loosen the wing bolt
and pull the guide off the front end of the
tool.
Press the shaft lock to lock the spindle in
place. Loosen the collet nut and insert the
wheel point into the collet nut.
Use the gauge (the gauge has
a
hex hole
which can be used
as a
wrench) to tighten
the collet nut securely.
Shaft lock
The wheel point should not be mounted
more than 10 mm
(3/8")
from the collet
nut. Exceeding this distance could cause
vibration or
a
broken shaft.
To
remove the wheel point, follow the installation procedures in
reverse.
7