Makita 9207SPB Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita 9207SPB. Makita 9207SPB 17 сторінок. Polisher
Також для Makita 9207SPB: Інструкція з експлуатації (12 сторінок), Інструкція з експлуатації (8 сторінок), Інструкція з експлуатації (8 сторінок)
Друкувати сторінку
OPERATION
MAINTENANCE
8
Fit the wool bonnet completely over the rubber pad and pull
003462
the string tight. Tie a bow knot and tuck the knot and any
loose strings between the wool bonnet and the rubber pad.
To remove the wool bonnet, follow the installation procedure
in reverse.
Sanding operation
003471
CAUTION:
•
Always wear safety goggles or a face shield during
operation.
15
•
Never switch on the tool when it is in contact with the
workpiece, it may cause an injury to operator.
•
Never run the tool without the abrasive disc. You may
seriously damage the pad.
Hold the tool firmly. Turn the tool on and then apply the abra-
sive disc to the workpiece.
In general, keep the abrasive disc at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result in
poor performance and premature wear to abrasive disc.
Polishing operation
003475
CAUTION:
•
Always wear safety glasses or a face shield during
operation.
Hold the tool firmly. Turn the tool on and then apply the wool
15
bonnet to the workpiece.
In general, keep the wool bonnet at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result in
poor performance and premature wear to wool bonnet.
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.