Makita BCS550 Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita BCS550. Makita BCS550 13 сторінок. Cordless metal cutter 136mm (5-3/8")
Також для Makita BCS550: Розбивка на частини (3 сторінок), Інструкція з експлуатації (12 сторінок), Інструкція з експлуатації (10 сторінок), Технічна інформація (13 сторінок)
Друкувати сторінку
Lighting the lamp
007527
CAUTION:
Do not look in the light or see the source of light
•
directly.
Only to turn on the light, pull the switch trigger without
pressing the lock-off lever. To turn on the light and run
the tool, press the lock-off lever and pull the switch
trigger with the lock-off lever being pressed.
NOTE:
Use a cotton stick to wipe the dirt off the lens of
•
lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Do not use gasoline, thinner or the like to clean
•
the lens of lamp. Using such substances will
damage the lens.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing blade
2
007528
CAUTION:
Be sure the blade is installed with teeth pointing
•
up at the front of the tool.
Use only the Makita wrench to install or remove
•
the blade.
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
1. Lamp
1
1. Shaft lock
2. Hex wrench
1
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
5
3
2
1
007529
When changing blade, make sure to also clean upper
and lower blade guards of accumulated chips and
particles. Such efforts do not, however, replace the
need to check lower guard operation before each use.
Hex wrench storage
1
007530
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If
not, it may accidentally fall out of the tool, causing
injury to you or someone around you.
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
Never twist or force the tool in the cut. This may
•
cause
motor
kickback, resulting in serious injury to the operator.
Always wear eye protection or goggle before
•
operation.
8
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
5. Cup washer
4
1. Hex wrench
overload
and/or
a
dangerous