KitchenAid Architect KGSS907XSP Розміри

Переглянути онлайн або завантажити pdf Розміри для Діапазони KitchenAid Architect KGSS907XSP. KitchenAid Architect KGSS907XSP 1 сторінка. 30" freestanding and slide-in gas range

Друкувати сторінку

PRODUCT MODEL NUMBERS

KGRS807S

KGSS907S

KGRS807X

KGSS907X

KGSK901S

GAS SUPPLY REQUIREMENTS

Use

" (1.9 cm) rigid pipe gas supply line to

the range location. A smaller size pipe on long

runs may result in insufficient gas supply. With

LP gas, piping or tubing size can be

(1.3 cm) minimum. If local codes permit, it is

recommended that new flexible metal tubing,

design-certified by CSA, 4-5 ft (122-152.4 cm)

long,

" (1.3 cm) or

" (1.9 cm) I.D., be used

for connecting the range to the rigid gas supply

line. A

" (1.3 cm) male pipe thread is needed

for connection to pressure regulator female

pipe threads. An easily accessible individual

manual shutoff valve must be located in the

same room, but external to the range.

ELECTRICAL REQUIREMENTS

120-volt, 60 Hz, AC-only, 15 amp, fused

electrical circuit is required. A separate circuit

is recommended. A time-delay fuse or circuit

breaker is recommended.

SLIDE-IN RANGE COUNTERTOP PREPARATION

The cooktop sides of the slide-in range fit over

the cutout edge of your countertop.

If you have a square finish (flat) countertop and

the opening width is 30" (76.2 cm), no

countertop preparation is required.

Formed front-edged countertops must have

molded edge shaved flat

" (1.0 cm) from each

front corner of opening.

CABINET OPENING DIMENSIONS

13" (33 cm) upper

cabinet depth

30" (76.2 cm) min.

opening width

18" (45.7 cm)

30" (76.2 cm)

upper cabinet

min. opening

to countertop

width

Grounded

outlet

5" (12.7 cm) min.

(15.2 cm)

clearance from

both sides of the

range to the side

(15.2 cm)

wall or other

7" (17.8 cm)

combustible

material.

Available area

for gas and electric

installation.

This shaded area

recommended for

Because Whirlpool Corporation policy includes a continuous commitment to improve

our products, we reserve the right to change materials and specifications without notice.

30" Freestanding and Slide-In Gas Range

OVERALL DIMENSIONS

" (14.6 cm)

B. 30" (76.2 cm)

C. 41 " (106 cm) overall height

with leveling legs screwed all

the way in.

D. 36" (91.4 cm) cooktop trim

height with leveling legs

screwed all the way in*

*Range can be raised approximately 1" (2.5 cm) by adjusting

the leveling legs.

**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)

countertop; front of oven door protrudes 1" (2.5 cm) beyond

24" (61 cm) base cabinet.

Tile countertops may need trim cut back

(1.0 cm) from each front corner and/or rounded

edge flattened.

If countertop opening width is greater than 30"

(76.2 cm), adjust the

Countertop must be level. Place level on

countertop, first side to side; then front to back.

If countertop is not level, range will not be level.

Range must be level for satisfactory baking

conditions.

For minimum

clearance to top

of the cooktop,

see NOTE.

Cabinet door

This shaded area

or hinge

recommended for

should not

installation of

extend into

outlet or

the cutout.

junction box.

installation of

rigid gas pipe.

Freestanding Range

F**

E. Model/serial number plate

(located on the right-hand

side oven door trim)

F. 27 " (69.2 cm) max. from

handle to standoff at back

of range**

" (1.0 cm) dimension.

13" (33 cm) max.

upper cabinet depth

30" (76.2 cm) min.

opening width

18" (45.7 cm)

upper cabinet

to countertop

5" (12.7 cm) min.

(15.2 cm)

clearance from

both sides of the

range to the side

(15.2 cm)

wall or other

combustible

7" (17.8 cm)

material.

This shaded area

recommended for

installation of

rigid gas pipe.

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

Slide-in Range

E**

A. 30

" (77.6 cm)

B. 35 " (90.5 cm) height to

underside of cooktop edge

with leveling legs screwed

all the way in*

C. Model/serial number plate

(located on the right-hand

side oven door trim)

*Range can be raised approximately 1" (2.5 cm) by adjusting

the leveling legs.

30"

(76.2 cm)

For minimum

clearance to top

of the cooktop,

see NOTE.

" (58.3 cm)

opening depth

30" (76.2 cm)

min. opening

width

Grounded

outlet

Cabinet door

This shaded area

or hinge

recommended for

should not

installation of

extend into

the cutout.

outlet or

junction box.

Available area

for gas and

electric

installation.

D 30" (76.2 cm)

on models KGRS807XSP and

KGSS907XSP) from handle to

standoff at back of range**

F. 23" (58.4 cm) countertop

notch to rear of cooktop

(1.0 cm)

(78.1 cm)

NOTE: 24" (61 cm)

minimum when bottom of

wood or metal cabinet is

covered by not less than

(0.64 cm) flame retardant

millboard covered with not

less than No. 28 MSG sheet

steel, 0.015" (0.4 mm)

stainless steel, 0.024"

(0.6 mm) aluminum or

0.020" (0.5 mm) copper.

30" (76.2 cm) minimum

clearance between the top of

the cooking platform and the

bottom of an uncovered

wood or metal cabinet.

If installing a range hood or

microwave hood combination

above the range, follow the

range hood or microwave

hood combination installation

instructions for dimensional

clearances above the cooktop

surface.

Ref. W10246118C

1/28/11